Cutting performance and surface quality of Ti-6Al-4V by longitudinal ultrasonic vibration-assisted high-speed dry milling with coated carbide tools

Experiments and finite element simulations on micro-milling of Ti–6Al–4V alloy with uncoated and cBN coated micro-tools

This paperpresentsexperimental investigationsandfinite element simulationsonmicro-millingofTi–6Al– 4V alloy with fine grain uncoated and cBN coated micro-end mills. Micro-milling of Ti–6Al–4V using uncoated and cBN coated tungsten carbide micro-end mills are conducted; surface roughness, burr formation and tool wear are measured. Effects of machining parameters on surface roughness, burr format...

The vacuum hot pressing behavior of silicon carbide fibers coated with nanocrystalline Ti–6Al–4V

The vacuum hot pressing (VHP) of silicon carbide monofilaments coated with nanocrystalline Ti–6Al–4V has been studied. During consolidation, very high densification rates were observed, even at temperatures and pressures well below those normally used for processing conventional Ti–6Al–4V. From the cross-sections of partially consolidated specimens, the evolution of coated fiber–fiber contacts ...

Fuzzy rule-based for predicting machining performance for SNTR carbide in milling titanium alloy (Ti-6Al-4v)

Dry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning

Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...

Fatigue of Ti-6Al-4V

Metallic biomaterials have essentially three fields of use; these are the artificial hip joints, screw, plates and nails for internal fixation of fractures, and dental implants. Any of these devices must support high mechanical load and resistance of material against breakage is essential. High mechanical properties are needed for structural efficiency of surgical and dental implants. But their...