منابع مشابه
Cutting rules in the real time formalisms at finite temperature
In this paper, we review the set of rules specific to the calculation of the imaginary part of a Green’s function at finite temperature in the real-time formalisms. Emphasis is put on the clarification of a recent controversy concerning these rules in the “1/2” formalism, more precisely on the issue related to the interpretation of these rules in terms of cut diagrams, like at T = 0. On the sec...
متن کاملCharacterization of Austenitic Stainless Steels Deformed at Elevated Temperature
Highly alloyed austenitic stainless steels are promising candidates to replace more expensive nickel-based alloys within the energy-producing industry. The present study investigates the deformation mechanisms by microstructural characterization, mechanical properties and stress–strain response of three commercial austenitic stainless steels and two commercial nickel-based alloys using uniaxial...
متن کاملPermittivity measurement of thermoplastic composites at elevated temperature.
The material properties of greatest importance in microwave processing of a dielectric are the complex relative permittivity epsilon = epsilon'-jepsilon", and the loss tangent, tan delta = epsilon"/epsilon'. This paper describes two convenient laboratory based methods to obtain epsilon', epsilon" and hence tan delta of fibre-reinforced thermoplastic (FRTP) composites. One method employs a micro...
متن کاملViscoelastic Properties of Nafion at Elevated Temperature and Humidity
Tensile stress–strain and stress relaxation properties of 1100 equivalent weight Nafion have been measured from 23 to 120 C at 0–100% relative humidity. At room temperature, the elastic modulus of Nafion decreases with water activity. At 90 C, the elastic modulus goes through a maximum at a water activity of 0.3. At temperatures 90 C, hydrated membranes are stiffer than dry membranes. Stressrel...
متن کاملProperties of Low-alloy High-speed Steel at Elevated Temperature
J. Jaworski, T. Trzepieciński: Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Rzeszów, Poland This paper presents the results of research on the determination of the coefficient of thermal conductivity and hot hardness of cutters made of selected grades of low-alloy high-speed steels, HS 6-5-2 and HS3-1-2. The investigations of hot hardness and yield stress...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1988
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.54.594