Cutting forces in unconstrained machining
نویسندگان
چکیده
منابع مشابه
Prediction of cutting forces in machining of metal matrix composites
This paper presents a mechanics model for predicting the forces of cutting aluminum-based SiC/Al2O3 particle reinforced MMCs. The force generation mechanism was considered to be due to three factors: (a) the chip formation force, (b) the ploughing force, and (c) the particle fracture force. The chip formation force was obtained by using Merchant’s analysis but those due to matrix ploughing defo...
متن کاملCutting Forces by Oak and Douglas Fir Machining
In this work the multi-factor, non-linear dependencies between main (tangential) FC and normal (radial) FN cutting forces upon two machining parameters by up-routing and down-routing wood of Douglas fir (Pseudotsuga menziesii) and Oak (Quercus petraea) were evaluated. The relationships are graphically illustrated and discussed. The obtained data were compared with cutting forces evolution model...
متن کاملSIMULATION AND MONITORING OF THE MACHINING PROCESS VIA FUZZY LOGIC AND CUTTING FORCES
On time replacement of a cutting tool with a new one is an important task in Flexible Manufacturing Systems (FMS). A fuzzy logic-based approach was used in the present study to predict and simulate the tool wear progress in turning operation. Cutting parameters and cutting forces were considered as the input and the wear rate was regarded as the output data in the fuzzy logic for construct...
متن کاملCharacteristics of cutting forces and chip formation in machining of titanium alloys
Chip formation during dry turning of Ti6Al4V alloy has been examined in association with dynamic cutting force measurements under different cutting speeds, feed rates and depths of cut. Both continuous and segmented chip formation processes were observed in one cut under conditions of low cutting speed and large feed rate. The slipping angle in the segmented chip was 551, which was higher than ...
متن کاملMonitoring and Control of Cutting Forces in Machining Processes: A Review
Much research has gone into machining process monitoring and control. This paper reviews monitoring and control schemes of cutting force and torque. Sensors to measure cutting force and torque, as well as their indirect estimation, are reviewed. Feedback control schemes and model-based feedforward scheduling schemes of cutting forces, as well as tool path optimization schemes for cutting force ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanik
سال: 2016
ISSN: 0025-6552
DOI: 10.17814/mechanik.2016.10.430