Cutting Forces in Milling of Carbon Fibre Reinforced Plastics
نویسندگان
چکیده
منابع مشابه
Some observations in grinding unidirectional carbon fibre-reinforced plastics
This paper investigates the grinding performance of epoxy matrix composites reinforced by unidirectional carbon fibres, using an alumina grinding wheel. Emphasis was placed on understanding the effect of fibre orientations and grinding depths on the grinding force and surface integrity, and on understanding the grinding mechanisms, with a comparison to orthogonal cutting. It was found that grea...
متن کاملJoining of Carbon Fibre Reinforced Plastics for Automotive Applications
The introduction of carbon-fibre reinforced plastics in load bearing automotive structures provides a great potential to reduce vehicle weight and fuel consumption. To enable the manufacture and assembly of composite structural parts, reliable and cost-effective joining technologies must be developed. This thesis addresses several aspects of joining and load introduction in carbon-fibre reinfor...
متن کاملSurface Quality of Staggered PCD End Mill in Milling of Carbon Fiber Reinforced Plastics
Machined surface quality determines the reliability, wear resistance and service life of carbon fiber reinforced plastic (CFRP) workpieces. In this work, the formation mechanism of the surface topography and the machining defects of CFRPs are proposed, and the influence of milling parameters and fiber cutting angles on the surface quality of CFRPs is obtained, which can provide a reference for ...
متن کاملOptimization of Laser Cutting Parameters on the Laminated Carbon Fibre Reinforced Plastics (CFRP) Composites Using DOE Technique
Nowadays, carbon fiber reinforced plastics (CFRP) composites is widely used in the aerospace industry due to its excellent mechanical properties. In laser cutting process, high powers are used to cut materials then material melts and burns leaving edges with a high quality finish. To fulfill the high demand of cutting quality, a set of laser cutting parameters of CFRP material are studied. The ...
متن کاملEffect of chisel edge in ultrasonic assisted drilling of carbon fibre reinforced plastics (CFRP)
Ultrasonic assisted drilling (UAD) has been reported effective for thrust force reduction during drilling of CFRP resulting in lower exit delamination. However, this process is not fully understood in relation to machining theory. This work focused on understanding the separate effects of chisel and cutting edges during UAD in comparison with conventional drilling (CD). Experiments were perform...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Manufacturing Engineering
سال: 2014
ISSN: 2356-7023,2314-5781
DOI: 10.1155/2014/439634