Cutting forces in gear machining by disk milling cutters
نویسندگان
چکیده
منابع مشابه
Milling machining of CFRPs: a model to simulate and forecast the cutting forces intime domain
The machining of fibre reinforced composites is an important activity for optimal application of these advanced materials into engineering fields. During machining, any excessive cutting force has to be avoided in order to prevent any product reject in the last stages of production cycle. Therefore, the ability to predict the cutting forces is essential to select the process parameters necessar...
متن کاملFlank milling with flat end milling cutters
In this paper, we give a detailed mathematical understanding of flank milling with flat end cutters, which we use to develop a method for milling with such a cutter. This method slides the cutter along two rails, providing two points of contact on the surface.
متن کاملCutting Forces by Oak and Douglas Fir Machining
In this work the multi-factor, non-linear dependencies between main (tangential) FC and normal (radial) FN cutting forces upon two machining parameters by up-routing and down-routing wood of Douglas fir (Pseudotsuga menziesii) and Oak (Quercus petraea) were evaluated. The relationships are graphically illustrated and discussed. The obtained data were compared with cutting forces evolution model...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملCutting forces parameters evaluation in milling using genetic algorithm
Simulation of the milling process is a widespread method to improve productivity in the machining process. Several phenomena can be studied and controlled by this mean. All the simulation methods need parameters that characterize the interaction between the tool and the workpiece in order to evaluate the cutting forces. Many models were developed to link efforts to macroscopic parameters (depth...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanics and Advanced Technologies
سال: 2018
ISSN: 2522-4255,2521-1943
DOI: 10.20535/2521-1943.2018.82.118609