Cutting forces and crater wear prediction in orthogonal cutting using two approaches of finite element modeling
نویسندگان
چکیده
منابع مشابه
the effect of tool rake angle and cutting speed on cutting force during broaching process by using finite element modeling
0
متن کاملEvaluation of Disc Cutter Performance in Rock Cutting Process Using 3D Finite Element Method
Today, numerical simulation can be used as a suitable tool to measure large quantities that are very expensive and, in some cases, impossible to measure. One of the important issues in predicting rock mass boreability in excavation with full face tunnel boring machines is estimating the discchr('39')s forces for rock cutting. For this purpose, the linear cutting test is employed. However, limi...
متن کاملInvestigation of Cutting Forces Superalloy Inconel 718
Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...
متن کاملPprediction of Cutting Forces in Micro-milling Process Using Finite Element Method
This paper presents the prediction of micro-milling forces using the finite element method (FE). An FE model of orthogonal micro-cutting with round cutting edge is developed. The cutting force coefficients are identified from a series of FE simulations at a range of cutting edge radii and chip loads. The identified cutting force coefficients are used to simulate micro-milling forces. The simula...
متن کاملChip Formation Process using Finite Element Simulation “Influence of Cutting Speed Variation”
The main aim of this paper is to study the material removal phenomenon using the finite element method (FEM) analysis for orthogonal cutting, and the impact of cutting speed variation on the chip formation, stress and plastic deformation. We have explored different constitutive models describing the tool-workpiece interaction. The Johnson-Cook constitutive model with damage initiation and damag...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Reports
سال: 2020
ISSN: 2577-8196,2577-8196
DOI: 10.1002/eng2.12240