Cutting Forces and Chip Morphology during Wood Plastic Composites Orthogonal Cutting
نویسندگان
چکیده
منابع مشابه
Investigation of Cutting Forces Superalloy Inconel 718
Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...
متن کاملPrediction of cutting forces in machining of metal matrix composites
This paper presents a mechanics model for predicting the forces of cutting aluminum-based SiC/Al2O3 particle reinforced MMCs. The force generation mechanism was considered to be due to three factors: (a) the chip formation force, (b) the ploughing force, and (c) the particle fracture force. The chip formation force was obtained by using Merchant’s analysis but those due to matrix ploughing defo...
متن کاملIn situ strain measurement in the chip formation zone during orthogonal cutting
The in situ strain measurements during orthogonal cutting were performed to get information about the local stress state in the chip formation zone. These results will be used to verify and extend existing chip formation models. Until now the existing chip formation models, e.g. [1-3] are relying on a number of restricting preconditions, because the strain and stress fields in the chip formatio...
متن کاملChip Formation Process using Finite Element Simulation “Influence of Cutting Speed Variation”
The main aim of this paper is to study the material removal phenomenon using the finite element method (FEM) analysis for orthogonal cutting, and the impact of cutting speed variation on the chip formation, stress and plastic deformation. We have explored different constitutive models describing the tool-workpiece interaction. The Johnson-Cook constitutive model with damage initiation and damag...
متن کاملA Slip-line Field for Ploughing during Orthogonal Cutting
Under normal machining conditions, the cutting forces are primarily due to the bulk shearing of the workpiece material in a narrow zone called the shear zone. However, under finishing conditions, when the uncut chip thickness is of the order of the cutting edge radius, a ploughing component of the forces becomes significant as compared to the shear forces. Predicting forces under these conditio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: BioResources
سال: 2014
ISSN: 1930-2126
DOI: 10.15376/biores.9.2.2090-2106