Cutting Force and Cutting Quality during Tapered Milling of Glass Magnesium Board

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fuzzy cutting force modelling in micro-milling

Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...

متن کامل

Influence of machining cycle of horizontal milling on the quality of cutting force measurement for the cutting tool wear monitoring

The cutting tools are today used a lot by industry and they are expensive, so it was interesting to optimize their use, by developing a predictive method of their wear, particularly, the flank wear Vb. For this task, the flank tool wear was measured in off-line using a binocular microscope, whereas, the cutting forces are recorded by means of a dynamometer (Kistler 9255B). The acquired signatur...

متن کامل

Cutting Force Prediction in End Milling Process of AISI 304 Steel Using Solid Carbide Tools

 In the present study, an attempt has been made to experimentally investigate the effects of cutting parameters on cutting force in end milling of AISI 304 steel with solid carbide tools. Experiments were conducted based on four factors and five level central composite rotatable design. Mathematical model has been developed to predict the cutting forces in terms of cutting parameters such as he...

متن کامل

Intelligent Adaptive Cutting Force Control in End-milling

In this article, an adaptive neural controller for the ball end-milling process is described. Architecture with two different kinds of neural networks is proposed, and is used for the on-line optimal control of the milling process. A BP neural network is used to identify the milling state and to determine the optimal cutting inputs. The feedrate is selected as the optimised variable, and the mi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Applied Sciences

سال: 2019

ISSN: 2076-3417

DOI: 10.3390/app9122533