Cutting Force Acting on Blunt Cutting Edge. 1st Report. A Basic Consideration on Cutting Force Occurrence.
نویسندگان
چکیده
منابع مشابه
Effects of Friction and Cutting Speed on Cutting Force
Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملthe effect of cutting speed on cutting force and surface quality in broaching of aluminum 7075
0
متن کاملA Methodology for Practical Cutting Force Evaluation Based on the Energy Spent in the Cutting System
& This paper presents a methodology for practical estimation of cutting force and cutting power. Based on a previously proposed definition, the power spent in metal cutting is the summation of four components: the power spent on the plastic deformation of the layer being removed by both major and minor cutting edges, the power spent on the tool-chip interface, the power spent on the tool-workpi...
متن کاملInvestigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning
In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2000
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.66.3760