Cutting Condition Monitoring in Milling Operation with Micro End mill
نویسندگان
چکیده
منابع مشابه
Modeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملReal-Time Cutting Tool Condition Monitoring in Milling
Reliable tool wear monitoring system is one of the important aspects for achieving a self-adjusting manufacturing system. The original contribution of the research is the developed monitoring system that can detect tool breakage in real time by using a combination of neural decision system and ANFIS tool wear estimator. The principal presumption was that force signals contain the most useful in...
متن کاملFuzzy cutting force modelling in micro-milling
Reliable prediction of cutting forces is essential for micromilling. In this paper, a fuzzy cutting force modelling method based on subtractive clustering method filters the noise and estimates the instantaneous cutting forces using observations acquired by sensors during cutting experiments. In the experimental case study, four data sets of micromilling cutting force are used. Each data set is...
متن کاملSurface Roughness Optimization in End Milling Operation with Damper Inserted End Milling Cutters
This paper presents a study of the Taguchi design application to optimize surface quality in damper inserted end milling operation. Maintaining good surface quality usually involves additional manufacturing cost or loss of productivity. The Taguchi design is an efficient and effective experimental method in which a response variable can be optimized, given various factors, using fewer resources...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2014
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.80.1031