Curved Continuous Casting of Glassy Alloy Sheets
نویسندگان
چکیده
منابع مشابه
Continuous Casting
Continuous casting is used to mass produce basic metals into long, semi-finished shapes with constant cross section, which are later processed into over 800 million tons of steel, 20 million tons of aluminum, and 1 million tons of copper, nickel, and other metal products in the world each year. Cross-sections can be rectangular, for later rolling into plate or sheet, square for long products, c...
متن کاملModeling of Continuous Casting
1 The high cost of empirical investigation in an operating steel plant makes it prudent to use all available tools in designing, troubleshooting and optimizing the process. Physical modeling, such as using water to simulate molten steel, enables significant insights into the flow behavior of liquid steel processes. The complexity of the continuous casting process and the phenomena which govern ...
متن کاملContinuous Casting of Steel
Continuous casting is used to solidify most of the 750 million tons of steel produced in the world every year. Like most commercial processes, continuous casting involves many complex interacting phenomena. Most previous advances have been based on empirical knowledge gained from experimentation with the process. To further optimize the design and improve the continuous casting process, mathema...
متن کاملDental casting of superelastic Ni-Ti alloy.
Rods of Ni-43.5wt% Ti alloy were prepared under various casting conditions. Specimens which were melted in a cordierite crucible and cast in a phosphate-bonded investment mold had less strength and elongation than those melted in a copper crucible and cast in a phosphate-bonded investment mold. All castings exhibited superelasticity at room temperature. The upper limit of recoverable strain was...
متن کاملThermal Simulation of Solidification Process in Continuous Casting
In this study, a mathematical model is introduced to simulate the coupled heat transfer equation and Stefan condition occurring in moving boundary problems such as the solidification process in the continuous casting machines. In the continuous casting process, there exists a two-phase Stefan problem with moving boundary. The control-volume finite difference approach together with the boundary ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Material Sciences
سال: 2012
ISSN: 2160-7613,2160-7621
DOI: 10.12677/ms.2012.23021