Current transformer ratio and phase error by test ring method
نویسندگان
چکیده
منابع مشابه
A New Method to Identify Fault Current and Inrush Current on Transformer by Jiles–atherton Model
This paper proposes a new method to detect transformer inside incipient fault current using transformer internal parameters to determine the inside structure of transformer at good condition or bad. A transformer model was established by Jiles– Atherton theory using measured voltage and current and the initial parameters which were found using Genetic Algorithm (GA). Then, transformer internal ...
متن کاملA Method for Calculation of the Inrush Current in Single Phase Transformer including the Residual Flux
A field-circuit method for simulation of transients in a single-phase, two-winding transformer has been given. The magnetic field excited by the winding currents has been analyzed, and integral parameters have been determined. Including the equivalent circuit parameters and the magnetic residual flux in the silicon steel core, the developed method has been implemented for the transitional state...
متن کاملMitigation Transformer Inrush Current Using Modified Transient Current Limiter
This study presents a modified transient current limiter (MTCL) for mitigation the inrush current of transformers. The MTCL is based on conventional transient current limiter (TCL), which, its configuration is modified to overcome the TCL drawbacks of operation. The proposed MTCL offers lower power losses and voltage/current THD during normal operation mode. It needs only one limiting reactor i...
متن کاملmodeling loss data by phase-type distribution
بیمه گران همیشه بابت خسارات بیمه نامه های تحت پوشش خود نگران بوده و روش هایی را جستجو می کنند که بتوانند داده های خسارات گذشته را با هدف اتخاذ یک تصمیم بهینه مدل بندی نمایند. در این پژوهش توزیع های فیزتایپ در مدل بندی داده های خسارات معرفی شده که شامل استنباط آماری مربوطه و استفاده از الگوریتم em در برآورد پارامترهای توزیع است. در پایان امکان استفاده از این توزیع در مدل بندی داده های گروه بندی ...
Flexible error-reduction method for shape measurement by temporal phase unwrapping: phase averaging method.
Temporal phase unwrapping is an important method for shape measurement in structured light projection. Its measurement errors mainly come from both the camera noise and nonlinearity. Analysis found that least-squares fitting cannot completely eliminate nonlinear errors, though it can significantly reduce the random errors. To further reduce the measurement errors of current temporal phase unwra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the American Institute of Electrical Engineers
سال: 1918
ISSN: 0097-2444
DOI: 10.1109/paiee.1918.6594161