Current Density on Microstructure and Thermal Control Performances of MgO-ZnO Ceramic Coatings
نویسندگان
چکیده
منابع مشابه
EFFECT OF CURRENT DENSITY ON MICROSTRUCTURE AND CORROSION BEHAVIOR OF PURE COBALT COATINGS OBTAINED
Pure cobalt coatings were electrodeposited on copper substrate by means of direct electric current in a chloride solution at different current densities in the range of 10-70 mA cm -2 . The surface morphology and microstructure were investigated via X-ray diffraction analysis and scanning electron microscopy. Corrosion behavior of cobalt coatings was also studied in a 3.5 wt% NaCl soluti...
متن کاملMicrowave Drilling of Ceramic Thermal-Barrier Coatings
The microwave drill is a novel process for creating shaped holes in nonconductive materials. Its inherent material selectivity makes the microwave drill ideally suited for the controlled removal of ceramic coatings from underlying metallic substrates. In this paper, it is shown that the microwave drill process can drill through ceramic thermal barrier coatings (TBCs) to uncover an array of simu...
متن کاملMicrostructure and Microwave Absorption Properties of Flame Sprayed Ceramic Coatings
In this research work, airplane grade aluminum alloy substrate was coated by Al2O3/ TiO2 ceramic coatings in two different compositions as 50:50 and 87:13 using Flame spraying technique. The surface & cross-sectional morphological characterizations of the Al2O3/ TiO2 powders and coatings were performed by scanning electron microscopy (SEM). The microwave absorbing properties of coatings were ex...
متن کاملThermal Barrier Ceramic Coatings — A Review
Thermal barrier coatings (TBCs) provide effective thermal barrier to the components of gas turbine engines by allowing higher operating temperatures and reduced cool‐ ing requirements. Plasma spraying, electron-beam physical vapor deposition, and sol‐ ution precursor plasma spray techniques are generally used to apply the TBCs on the metallic substrates. The present article addresses the TBCs f...
متن کاملMicrostructure, deformation and cracking characteristics of thermal spray ferrous coatings
The microstructure and local mechanical characteristics of thermal spray ferrous coatings have been determined. The emphasis has been on coatings made by the high velocity oxyfuel (HVOF) process, especially the role of Al alloy additives. The oxide phase present in the material and preferred pathways for local cracking and separation have been determined. Thin intersplat oxide layers emerge as ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Inorganic Materials
سال: 2017
ISSN: 1000-324X
DOI: 10.15541/jim20170057