Cure kinetics of bismaleimides as basis for polyimide-like inks for PolyJet™-3D-printing
نویسندگان
چکیده
منابع مشابه
Microfluidic Printheads for Multimaterial 3D Printing of Viscoelastic Inks.
Multimaterial 3D printing using microfluidic printheads specifically designed for seamless switching between two visco-elastic materials "on-the-fly" during fabrication is demonstrated. This approach opens new avenues for the digital assembly of functional matter with controlled compositional and property gradients at the microscale.
متن کاملEmulsion Inks for 3D Printing of High Porosity Materials.
Photocurable emulsion inks for use with solid freeform fabrication (SFF) to generate constructs with hierarchical porosity are presented. A high internal phase emulsion (HIPE) templating technique was utilized to prepare water-in-oil emulsions from a hydrophobic photopolymer, surfactant, and water. These HIPEs displayed strong shear thinning behavior that permitted layer-by-layer deposition int...
متن کاملCellulose Nanocrystal Inks for 3D Printing of Textured Cellular Architectures
© 2017 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim wileyonlinelibrary.com (1 of 10) 1604619 exiting the nozzle, is challenging. A viscoelastic response with a finite yield stress is required for filament patterning.[3] The shear-induced alignment of anisotropic building blocks, including carbon fibers,[4,5] silicon carbide whiskers,[5] alumina platelets,[3] and nanofibrillated cellulose (NFC)[6]...
متن کامل3d-printing of Energy Devices Using Particle-based Inks
Introduction and Summary Over the past year, ISEN funding has been utilized to make significant research progress towards the fabrication of a fully 3D-printed iron/solid oxide fuel cell (Metallic/multi-ceramic) batterygenerator system (Figure 1). Monies have gone towards the partial funding of one grad student/postdoc, Adam Jakus, in Ramille Shah’s Tissue Engineering and Additive Manufacturing...
متن کاملHydrophilic elastomers for microcontact printing of polar inks.
A moderately hydrophilic, thermoplastic elastomer (poly(ether-ester)) was investigated as a stamp material for microcontact printing of a polar ink: pentaerythritol-tetrakis-(3-mercaptopropionate). Stamps with a relief structure were produced from this polymer by hot embossing, and a comparison was made with conventional poly(dimethylsiloxane) (PDMS) and oxygen-plasma-treated PDMS. It is shown ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Polymer Science
سال: 2018
ISSN: 0021-8995
DOI: 10.1002/app.47244