Cu2ZnSnS4 thin film solar cells grown by fast thermal evaporation and thermal treatment
نویسندگان
چکیده
منابع مشابه
Al-Doped ZnO Thin Film Transistors by Thermal Evaporation
In this paper, Al-doped ZnO thin film transistors (AZO-TFT) were fabricated by the thermal evaporation growth of AZO channel layer on a silicon substrate at temperatures below 250°C. A SiO2 dielectric layer grown by the horizontal furnace was used as a gate. An active layer thickness of 10nm was measured by Atomic Force Microscopy (AFM), and its surface had root mean square (rms) roughness 12.6...
متن کاملCu2ZnSnS4 Thin Film Solar Cells: Present Status and Future Prospects
Pollution of the earth and shortage of energy sources have been the bottle-neck of survival and development for human beings since the start of the 21st century. Therefore, lowering energy consumption and protecting the environment have gradually gained attention from countries all over the world. In order to keep sustainable development, governments, re‐ search institutes, and industries have ...
متن کاملSolar Cells using Congruent Thermal Evaporation
Although highly valuable as an R&D tool, ALD is a rather slow and thus expensive fabrication method for growing fi lms on the order of 1 μm thick, posing a challenge to industrial scaleup. Hence, there is a need to transfer learnings from ALD to higher-throughput manufacturing techniques without compromising quality. We fi rst demonstrate the ease of phase purifi cation of commercial SnS powder...
متن کاملThin-Film Flow Influenced by Thermal Noise
We study the influence of thermal fluctuations on the dewetting dynamics of thin liquid films. Starting from the incompressible Navier-Stokes equations with thermal noise, we derive a fourth-order degenerate parabolic stochastic partial differential equation which includes a conservative, multiplicative noise term—the stochastic thin-film equation. Technically, we rely on a long-wave-approximat...
متن کاملStudies on Optical Properties of ZnS Thin Film by Thermal Evaporation Technique
The most significant process for optical coating is variant of vacuum deposition. Zinc sulphide having direct and large band gap which is use in opto electronics. By using ZnS material in thermal evaporation technique and characterizing the minimum reflectance and maximum transmittance in visible wavelength and energy gap increases with increasing thickness having direct and large band gap. Whe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Solar Energy
سال: 2017
ISSN: 0038-092X
DOI: 10.1016/j.solener.2016.11.035