Cu-Hf-Al amorphous/nanocrystalline composite particles produced by milling
نویسندگان
چکیده
منابع مشابه
PREPARATION AND SINTERING OF W-20%Wt Cu COMPOSITE POWDERS PRODUCED BY CO-PRECIPITATION METHOD
Abstract: materials can be fabricated by sintering of W-Cu composite powders. In this research W-20%wt Cu composite powderswas synthesized via a co-precipitation method. Precipitate obtained from a mixture of copper nitrate and ammoniumparatungstate (APT) in distilled water contained W-Cu compounds. This precipitate was washed, dried and calcinedat 550 of dried precipitate powder was determined...
متن کاملSecondary Particles Produced by Hadron Therapy
Introduction Use of hadron therapy as an advanced radiotherapy technique is increasing. In this method, secondary particles are produced through primary beam interactions with the beam-transport system and the patient’s body. In this study, Monte Carlo simulations were employed to determine the dose of produced secondary particles, particularly neutrons during treatment. Materials and Methods I...
متن کاملTHE FEASIBILITY STUDY OF W-Cu COMPOSITE PRODUCTION BY SUBMICRON PARTICLES ADDITION AND INFILTRATION
In this paper the feasibility of fabricating controlled porous skeleton of pure tungsten at low temperature by addition of submicron particles to tungsten powder (surface activated sintering) has been studied and the best parameters for subsequent infiltration of Cu were acquired. The effects of addition of submicron particles and sintering temperature on porous as well as infiltrated samples w...
متن کاملProduction and microstructural investigation of Al-nano TiB2 composite produced by powder metallurgy technique
Automotive and aerospace industries are required to light materials which have high properties. This causes to reduce production cost and fuel consumption. One of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. These materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. Powder metal...
متن کاملProduction and microstructural investigation of Al-nano TiB2 composite produced by powder metallurgy technique
Automotive and aerospace industries are required to light materials which have high properties. This causes to reduce production cost and fuel consumption. One of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. These materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. Powder metal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Epitoanyag - Journal of Silicate Based and Composite Materials
سال: 2013
ISSN: 0013-970X
DOI: 10.14382/epitoanyag-jsbcm.2013.8