Cryo-SEM Observation of Coating Layer on Powder Surface
نویسندگان
چکیده
منابع مشابه
Cryo-SEM studies of latex/ceramic nanoparticle coating microstructure development.
Cryogenic scanning electron microscopy (cryo-SEM) was used to investigate microstructure development of composite coatings prepared from dispersions of antimony-doped tin oxide (ATO) nanoparticles (approximately 30 nm) or indium tin oxide (ITO) nanoparticles (approximately 40 nm) and latex particles (polydisperse, D(v): approximately 300 nm). Cryo-SEM images of ATO/latex dispersions as-frozen s...
متن کاملDouble layer coating for high resolution low temperature SEM
Specimen damage caused by mass loss due to electron beam irradiation is a major limitation in Low Temperature Scanning Electron Microscopy of bulk specimens. At high primary magnifications (e.g. 100 000 x) a hydrated sample is usually severely damaged after one slow scan (about 3000 enm-2). The consequences of this beam damage are remarkably reduced by coating the frozen-hydrated sample with a ...
متن کاملD uble layer coating for high resolution low temperature SEM
Specimen damage caused by mass loss due to electron beam irradiation is a major limitation in Low Temperature Scanning Electron Microscopy of bulk specimens. At high primary magnifications (e.g. 100 000 x) a hydrated sample is usually severely damaged after one slow scan (about 3000 enm-2). The consequences of this beam damage are remarkably reduced by coating the frozen-hydrated sample with a ...
متن کاملDip coating of silica layer on melt-spun Finemet ribbons: surface morphology and electrical resistivity changes
In this study, melt-spun Finemet ribbons were coated by a thin layer of SiO2 using dip coating method. Amorphous ribbon prepared by melt spinning method and dip coating were done by using a solution of tetraethylen orthosilicate as a SiO2 precursor, ethanol as solvent and distilled water for hydrolysis. Different thicknesses of SiO2 layer, namely 304, 349, 451, 526 and 970 nm were obtained prop...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Powder Technology, Japan
سال: 2019
ISSN: 0386-6157,1883-7239
DOI: 10.4164/sptj.56.15