Critical Current Density and Microstructure of NdBa2Cu3O7Single Crystal

EFFECT OF CURRENT DENSITY ON MICROSTRUCTURE AND CORROSION BEHAVIOR OF PURE COBALT COATINGS OBTAINED

Pure cobalt coatings were electrodeposited on copper substrate by means of direct electric current in a chloride solution at different current densities in the range of 10-70 mA cm -2 . The surface morphology and microstructure were investigated via X-ray diffraction analysis and scanning electron microscopy. Corrosion behavior of cobalt coatings was also studied in a 3.5 wt% NaCl soluti...

Influence of Preparation Process on Microstructure, Critical Current Density and Tc of MgB2/Fe/Cu Wires

The powder-in-tube MgB2 wires were prepared by high energy milling of Mg and B powder. The powder was not mechanically alloyed for 2h short milling time. However, the MgB2 grains in wires are very small (20 100nm) and resembled to the dimple after post-heat treatment. The clear evidence for transcrystlline fracture is observed. It indicated that the grain connection was greatly improved and the...

High Critical Current Density Superconductivity

This project was focused on a basic scientific problem, one that is at the heart of application and development of superconductivity for efficient energy usage. This is improvement in high current density which can only be achieved by learning to pin vortices to the physical structure of its underlying superconducting material. Quantized vortices are the tornado of electrical supercurrents, ubi...

High Critical Current Density MgB

The Impact of Current Density of Electroplating on Microstructure and Mechanical Properties of Ni-ZrO2-TiO2 Composite Coating

Metallic composite coatings with ceramic particles can be used to improve the mechanical and corrosion properties of steel. In the present research, Ni-ZrO2-TiO2 composite coating was fabricated on AISI 430 stainless steel through the electrodeposition method. The effect of the current density of electroplating (15, 17, 20, and 23 mA.cm-2)was investigated on the...