Crevice Corrosion Characteristics of Zr-2.5wt%Nb Alloy and SUS403Mod in High Temperature Pure Water.
نویسندگان
چکیده
منابع مشابه
Nitrogen and Water in High Temperature Corrosion
Service life-time of alloys used in high temperature applications is often limited by corrosion. FeCrAl(Re) alloys are partially designed to form a protective α-alumina oxide scale at elevated temperatures in order to mitigate further oxidation. The scale growth commonly follows a parabolic rate law, which under a Wagnerian setting depends on transport of charged species; ions, vacancies and el...
متن کاملCorrosion Properties of F82H in Flowing High Temperature Pressurized Water
This work reports the effects of water flow and dissolved oxygen (DO) on corrosion behavior of reduced activation ferritic/martensitic steel, F82H. The corrosion tests were performed in high temperature pressurized water by using a test apparatus for rotated disk sample. All of specimens showed weight gains after static corrosion tests up to 500 h. However, the rotated disk showed weight losses...
متن کاملSurface characteristics and castability of Zr-14Nb alloy dental castings.
The purpose of this study was to evaluate mechanical properties, surface characteristics and castability of Zr-14Nb dental castings. The mean 0.2% proof and ultimate tensile strengths of Zr-14Nb were approximately 68% and 76% those of Ti-6Al-7Nb, respectively, while they were comparable to Co-29Cr-6Mo. Elongation of Zr-14Nb was the highest of all alloys tested. The hardened reaction layer was f...
متن کاملHigh-Temperature Stability and Grain Boundary Complexion Formation in a Nanocrystalline Cu-Zr Alloy
Nanocrystalline Cu-3 at.% Zr powders with 20 nm average grain size were created with mechanical alloying and their thermal stability was studied from 550–950 C. Annealing drove Zr segregation to the grain boundaries, which led to the formation of amorphous intergranular complexions at higher temperatures. Grain growth was retarded significantly, with 1 week of annealing at 950 C, or 98% of the ...
متن کاملCombining the Ohmic Drop and Critical Crevice Solution Approaches to Rationalize Intermediate Attack in Crevice Corrosion
Crevice corrosion material loss is often most severe at intermediate distances into the crevice. This intermediate attack can be rationalized using the ohmic drop model of Pickering if and only if the material in question exhibits active/passive behavior in the crevice environment. Conventional theories that ascribe control of crevice corrosion to chemical changes exclusively cannot rationalize...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Atomic Energy Society of Japan / Atomic Energy Society of Japan
سال: 1995
ISSN: 0004-7120
DOI: 10.3327/jaesj.37.526