منابع مشابه
Measurement and Modeling of Creep in Open-Cell NiAl Foams
Nickel-rich NiAl foams, consisting of open cells with hollow struts and exhibiting two relative densities (5.0 and 6.6 pct) and average cell sizes (1.27 and 0.85 mm), were creep tested between 800 °C and 1100 °C under compressive stresses between 0.10 and 1.50 MPa. For stresses lower than 0.50 MPa, the foams exhibit secondary creep with power-law behavior characterized by creep exponents and ac...
متن کاملAutomation in Measurement of Inverse Creep In Nylon Textile Yarns
From decades Creep has been known and studied for textile materials. In comparison, a newly observed phenomenon of inverse creep seems not to have received much attention. A new instrument has been fabricated to measure creep and inverse creep in textile materials particularly yarns. Creep and Inverse creep measurements of few of the textile yarns like nylon multifilament yarn, Polyester multif...
متن کاملMeasurement of local creep properties in stainless steel welds
A high temperature measurement system for creep deformation based on the digital image correlation (DIC) technique is described. The new system is applied to study the behaviour of a multi-pass welded joint in a high temperature tensile test and a load controlled creep test at 545°C. Spatially resolved tensile properties and time dependent creep deformation properties across a thick section typ...
متن کاملCreep motion of a model frictional system.
We report on the dynamics of a model frictional system submitted to minute external perturbations. The system consists of a chain of sliders connected through elastic springs that rest on an incline. By introducing cyclic expansions and contractions of the springs we observe a reptation of the chain. We account for the average reptation velocity theoretically. The velocity of small systems exhi...
متن کاملStudy of cavities in a creep crack growth test specimen
During their operation, modern aircraft engine components are subjected to increasingly demanding operating conditions, especially the high pressure turbine (HPT) blades. Such conditions cause these parts to undergo different types of time-dependent degradation, one of which is creep. A model using the finite element method (FEM) was developed, in order to be able to predict the creep behaviour...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JAPAN TAPPI JOURNAL
سال: 1997
ISSN: 0022-815X,1881-1000
DOI: 10.2524/jtappij.51.319