Creep Property Evaluation of 12%Cr Ferritic Steel Welded Joint by Modified Small Punch Creep Test
نویسندگان
چکیده
منابع مشابه
Evaluation of Creep Properties of Steel P92 and Its Welded Joint
P. Mohyla, R. Cep, Faculty of Mechanical Engineering, VSB-Technical University of Ostrava, Czech Republic; Z. Kubon, Materials and Metallurgical Re search, Lt d., Cz ech Re p.; I . S amardzic, Jo sip Ju raj Strossmayer Un iversity of Osijek Mechanical Engineering Faculty i n Slavonski Brod Croatia This work is focused on testing and evaluation of creep properties of P92 base material (BM) and w...
متن کاملCorrelation Factor Study of Small Punch Creep Test and Its Life Prediction
A small punch test is one of the innovative methods that can be used to evaluate the properties of a material without destructive harm to the in-service component. Conventionally identifying material properties by a uniaxial test is widely applied to engineering. How the properties obtained from a small punch test can be applied with the same utility has been a goal. In 2006, European Code of P...
متن کاملCreep Deformation Measurement of 316H Stainless Steel Multi-pass Welded Joints using Digital Image Correlation
A high temperature measurement system for creep deformation based on the digital image correlation (DIC) technique is described. The new system is applied to study the behaviour of a multi-pass welded joint in a high temperature tensile test and a load controlled creep test at 545°C. Spatially resolved tensile properties and time dependent creep deformation properties across a thick section typ...
متن کاملFerritic Alloys with Extreme Creep Resistance via Coherent Hierarchical Precipitates
There have been numerous efforts to develop creep-resistant materials strengthened by incoherent particles at high temperatures and stresses in response to future energy needs for steam turbines in thermal-power plants. However, the microstructural instability of the incoherent-particle-strengthened ferritic steels limits their application to temperatures below 900 K. Here, we report a novel fe...
متن کاملLecture 14 : Creep – Resistant Steel , Case Study
Introduction Typical operating parameters for steels used in the manufacture of power plant are compared against corresponding values for nickel alloys in aeroengines, in Table 1. In both cases, the service conditions are severe. But this is especially so for steels where the service life is many decades. The degree of reliability demanded of heat resistant steels is therefore extraordinary, an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2016
ISSN: 0514-5163,1880-7488
DOI: 10.2472/jsms.65.306