Creep of nearly lamellar TiAl alloy containing W
نویسندگان
چکیده
منابع مشابه
Creep of nearly lamellar TiAl alloy containing W
Effects of W on the creep resistance of two nearly fully lamellar TiAl alloys with 1.0 and 2.0 at.% W have been investigated. In the low stress regime (LS) a nearly quadratic (1:5 < n < 2) creep behavior was observed. It is found that the addition of W can improve the creep resistance; however, the addition of excess W can result in the formation of b phase, which produces an adverse effect on ...
متن کاملCreep Mechanisms and Interface-Enhanced Deformation Twinning in a Two-Phase _ Lamellar TiAl Alloy
Deformation mechanisms and the role of interfaces in deformation twinning of a two-phase [TiAI (y)GAl (ad] 1 amellar allo\t creep deformed at elevated temperatures have been investigated. Since the multiplication of lattice dislocations \vithin both y and a2 lamellae is verl\’ limited at a lo\v stress level due to a refined lamellar microstructure, the glide of interfacial dislocations on both ...
متن کاملRole of Interfacial Dislocations on Creep of a Fully Lamellar TiAl
Deformation mechanisms of a fully lamellar TiAl (γ lamellae: 100 ~ 300Ênm thick, α2 lamellae: 10 ~ 50 nm thick) crept at 760¡C have been investigated. It was found that, as a result of a fine structure, the motion and multiplication of dislocations within both γ and α2 lamellae are limited at low creep stresses (< 400 MPa). Thus, the glide and climb of lattice dislocations have insignificant co...
متن کاملThermal-cycling creep of g-TiAl-based alloys
In two-phase TiAl-based alloys, the coexisting 2 and phases exhibit a thermal expansion mismatch, so that increased creep rates during thermal cycling may be expected. Creep deformation of two g-TiAl-based alloys was investigated during thermal cycles between 900 and 300 or 350 C with applied tensile stresses of 32.5 or 37.0 MPa. Measured thermal cycling creep rates were compared with isotherma...
متن کاملAn Atomistic Study of Interfacial Diffusion in Lamellar TiAl Alloys
In this paper we investigate self-diffusion of Ti and Al along interfaces present in the lamellar L10 TiAl by atomistic computer modeling. The interactions between the atoms are described by centralforce many-body potentials. The approach adopted is similar to that used in earlier atomistic modeling of bulk diffusion in TiAl [1, 2]. Both the formation and migration of vacancies is examined. The...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scripta Materialia
سال: 2004
ISSN: 1359-6462
DOI: 10.1016/j.scriptamat.2004.05.005