CREEP-FATIGUE OF HIPED Ti-48at%Al AND Ti-50at%Al INTERMETALLICS
نویسندگان
چکیده
منابع مشابه
Fatigue of Ti-6Al-4V
Metallic biomaterials have essentially three fields of use; these are the artificial hip joints, screw, plates and nails for internal fixation of fractures, and dental implants. Any of these devices must support high mechanical load and resistance of material against breakage is essential. High mechanical properties are needed for structural efficiency of surgical and dental implants. But their...
متن کاملFatigue and corrosion fatigue properties of Ti-6Al-4V implant grade titanium alloy in Ringer solution
Nowadays modification of metallic biomaterials which are used as implants for bone and hard tissues replacement is considered as an important subject. In the current study, corrosion fatigue properties of Ti-6Al-4V alloy investigated via Rotating-Bending standard test method and then, the results compared with the fatigue properties of the specimens tested in the same conditions. Scanning elect...
متن کاملA Model for Creep and Creep Damage in the γ-Titanium Aluminide Ti-45Al-2Mn-2Nb
Gamma titanium aluminides (γ-TiAl) display significantly improved high temperature mechanical properties over conventional titanium alloys. Due to their low densities, these alloys are increasingly becoming strong candidates to replace nickel-base superalloys in future gas turbine aeroengine components. To determine the safe operating life of such components, a good understanding of their creep...
متن کاملCorrosion Characteristics of a - Ti and Ti 2 Cu Composing Ti - Cu Alloys
A series ef binary Ti-Cu alloys containing 5-20 mass% Cu was prepared, and the corresien behavior of a-Ti and Ti2Cu composing the Ti-Cu alloys were examined based on the anodic polarization curves and released iens in O.9% NaCl and 1% lactic acid solutions. In both selutions, the Ti-Cu alloys showed the same anodic polarization curves as titanium in the conditien below 1.4 V. Hewever, precipita...
متن کاملFatigue properties of Ni-43.5%Ti superelastic alloy castings.
To evaluate a Ni-43.5wt%Ti alloy as a new alloy for cast clasp, the fatigue properties of its castings were examined and compared with those of Co-Cr and Type IV Au alloys castings. The Ni-Ti alloy was cast into a phosphate-bonded investment mold using an argon-arc melting and pressure casting machine. The Ni-Ti alloy castings showed superelasticity in bending tests. Fatigue tests were carried ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1995
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.44.504appendix_181