CREEP FAILURE TIME OF THIN-WALLED PIPES UNDER COMBINED TORSION, BENDING AND TENSION
نویسندگان
چکیده
منابع مشابه
Experimental Investigations into the Collapse of Simple and Reinforced Thin-Walled Channel Beams under Bending Loads
In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...
متن کاملExperimental Investigations into the Collapse of Simple and Reinforced Thin-Walled Channel Beams under Bending Loads
In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...
متن کاملPipes under Internal Pressure and Bending
This article covers the general behaviour of a straight uniform pipe, with built-in open ends, subject to internal pressure and in plane bending or curvature. It is intended as a summary of the basic equations driving the unintuitive phenomena of bending and instability of pipes under internal pressure. The analysis covers in addition the investigation of opposite pressure stabilisation effects...
متن کاملLong-Term Bending Creep Behavior of Thin-Walled CFRP Tendon Pretensioned Spun Concrete Poles
This paper discusses the long-term behavior of a series of highly-loaded, spun concrete pole specimens prestressed with carbon fiber-reinforced polymer (CFRP) tendons, which were subjected to outdoor four-point bending creep tests since 1996 in the frame of collaboration with the Swiss precast concrete producer, SACAC (Società Anonima Cementi Armati Centrifugati). The 2 m span cylindrical beams...
متن کاملThe Effect of Normal Anisotropy on Thin-Walled Tube Bending
Thin-walled tube bending has common applications in the automobile and aerospace industries. The rotary-draw-bending method is a complex physical process with multi-factor interactive effects and is one of the advanced tube forming processes with high efficiency, high forming precision, low consumption and good flexibility for bending angle changes. However, it may cause a wrinkling phenomenon,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ERJ. Engineering Research Journal
سال: 2009
ISSN: 1110-1180
DOI: 10.21608/erjm.2009.69484