Creep degradation assessment in 9%Cr heat-resistant steel welded joints using ultrasonic methods
نویسندگان
چکیده
منابع مشابه
Creep Deformation Measurement of 316H Stainless Steel Multi-pass Welded Joints using Digital Image Correlation
A high temperature measurement system for creep deformation based on the digital image correlation (DIC) technique is described. The new system is applied to study the behaviour of a multi-pass welded joint in a high temperature tensile test and a load controlled creep test at 545°C. Spatially resolved tensile properties and time dependent creep deformation properties across a thick section typ...
متن کاملThe Influence of Ultrasonic Impact Treatment on Fatigue Behaviour of Welded Joints in High-strength Steel
The unabated growth of the steel industry and progressively increasing operating loads on metal structures generate a need for a search for optimum engineering solutions to improve the loadcarrying capacity and reduce metal consumption. One way of resolving this problem is to utilise high-strength steels. It is common knowledge however that the improvement of the steel strength is accompanied b...
متن کاملImproving Fatigue Strength of Welded Joints by Ultrasonic Impact Treatment
Enhancement in fatigue performance of welded joints by Ultrasonic Impact Treatment (UIT) was evaluated with large-scale rolled beam and built-up specimens having yield strength of 345 to 760 MPa. Eighteen rolled-beam specimens having welded details at cover plates and transverse stiffeners and eight built-up specimens having only transverse stiffener details were fatigue tested after treating t...
متن کاملFatigue Assessment of Complex Welded Steel Structures
To improve the usage of material in fatigue loaded complex welded structures a better calculation method (based on FEA) is needed than what is available on the market and an improved management of weld quality. Improved FE-procedures are directly applicable to design of generic structural components within virtually all industries using CAD and FEtools, irrespective of industrial sector. More a...
متن کاملLecture 14 : Creep – Resistant Steel , Case Study
Introduction Typical operating parameters for steels used in the manufacture of power plant are compared against corresponding values for nickel alloys in aeroengines, in Table 1. In both cases, the service conditions are severe. But this is especially so for steels where the service life is many decades. The degree of reliability demanded of heat resistant steels is therefore extraordinary, an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Results in Physics
سال: 2019
ISSN: 2211-3797
DOI: 10.1016/j.rinp.2018.11.061