Creep Behavior of a Cast TiAl Intermetallics
نویسندگان
چکیده
منابع مشابه
Compressive creep behavior of cast Bi2Te3
In thermoelectric devices, Bi2Te3 must be able to operate under high temperature gradients for very long times (years) without appreciable deformation, while being subjected to stresses created by internal thermal mismatch and external forces (e.g., vibrations). The deformation rate of cast, coarsegrained Bi2Te3 was measured under uniaxial compressive stresses from 2 to 16 MPa at temperatures b...
متن کاملCreep Behavior of Al-Si Die-Cast Alloys
Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...
متن کاملCreep of nearly lamellar TiAl alloy containing W
Effects of W on the creep resistance of two nearly fully lamellar TiAl alloys with 1.0 and 2.0 at.% W have been investigated. In the low stress regime (LS) a nearly quadratic (1:5 < n < 2) creep behavior was observed. It is found that the addition of W can improve the creep resistance; however, the addition of excess W can result in the formation of b phase, which produces an adverse effect on ...
متن کاملThermal-cycling creep of g-TiAl-based alloys
In two-phase TiAl-based alloys, the coexisting 2 and phases exhibit a thermal expansion mismatch, so that increased creep rates during thermal cycling may be expected. Creep deformation of two g-TiAl-based alloys was investigated during thermal cycles between 900 and 300 or 350 C with applied tensile stresses of 32.5 or 37.0 MPa. Measured thermal cycling creep rates were compared with isotherma...
متن کاملDeformation Behavior of Intermetallics: Models and Experiments
A sufficiently general thermally activated mechanism for extension of dislocations in some preferential direction was proposed. This mechanism comprises a necessary step of dislocation transformations that lead to blocking. The reasons for blocking of different types of dislocations in different materials are diverse. A new concept was developed concerning the possibility of thermally activated...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1989
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.53.4_471