Creep and Creep Rupture Properties of Sn-8Zn-3Bi Solder
نویسندگان
چکیده
منابع مشابه
Creep Behavior of a Sn-Ag-Bi Pb-Free Solder
Compression creep tests were performed on the ternary 91.84Sn-3.33Ag-4.83Bi (wt.%, abbreviated Sn-Ag-Bi) Pb-free alloy. The test temperatures were: −25 °C, 25 °C, 75 °C, 125 °C, and 160 °C (± 0.5 °C). Four loads were used at the two lowest temperatures and five at the higher temperatures. The specimens were tested in the as-fabricated condition or after having been subjected to one of two air a...
متن کاملCreep and Creep–Rupture Behavior of Wood-Based Structural Panels
This paper summarizes a cooperative research program between the USDA Forest Service, Forest Products Laboratory (FPL), in Madison, Wisconsin, and Forintek Canada Corp. in Vancouver, British Columbia, Canada. This research program provided detailed creep–rupture and some creep information for composite panel products. Commercially produced plywood, oriented strandboard (OSB), and minimally alig...
متن کاملA Creep Model for Solder Alloys
Demand for long-term reliability of electronic packaging has lead to a large number of studies on viscoplastic behavior of solder alloys. Various creep models for solder alloys have been proposed. They range from purely empirical to mechanism based models where dislocation motion and diffusion processes are taken into account. In this study, most commonly used creep models are compared with the...
متن کاملCorrelation between Zn-Rich Phase and Corrosion/Oxidation Behavior of Sn–8Zn–3Bi Alloy
The microstructure of Sn–8Zn–3Bi alloy was refined by increasing the solidification rate and the correlation between Zn-rich phase and the corrosion/oxidation behavior of the alloy was investigated. The Zn-rich phase transforms from coarse flakes to fine needles dispersed in the β-Sn matrix with the increase of the cooling rate. The transformation of Zn-rich precipitates enhances the anticorros...
متن کاملIndentation vs. Uniaxial Power-law Creep of Sn-based Solder Material: A Numerical Assessment
It is crucial to understand the creep behavior of Pb-free solder alloys in electronic packaging. Typical service environments are between 298 and 373K. The thermal mismatch induced stresses acting on solder joints result in extensive rate-dependent plastic deformation. The solder alloy is potentially the weakest component in the electronic package because normal operating temperatures are alrea...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2007
ISSN: 0514-5163,1880-7488
DOI: 10.2472/jsms.56.129