Cracking in Zinc Layers on Continuous Galvanized Sheets: A Review
نویسندگان
چکیده
منابع مشابه
Determination of the Forming Limit Diagram of Zinc Electro-galvanized Steel Sheets
Forming limit curves (FLC) of deep drawing steel sheets have been determined experimentally and calculated on the base of the material tensile properties following the Hill, Swift, Marciniak-Kuczyński and Sing-Rao methods. Only the FLC modeled from a singly linear forming limit stress curve exhibits good consistence with experimental curve. It was established that a linearized limit stress locu...
متن کاملCracking sheets: oscillatory fracture paths in thin elastic sheets.
When a blunt cutting tool is forced through a thin elastic sheet that is held along its lateral boundaries, a strikingly regular wavy cut can be left behind, examples of which are presented in Fig. 1. The thin film is brittle, hence it undergoes negligible irreversible deformation besides fracture. For tools much wider than the film’s thickness, the crack tip follows a highly reproducible nonsi...
متن کاملA Predictive Model Accounting for the Mechanical Behavior of Galvanized Alloy Layers on the Mild Steel
Zinc coating is formed by the heterogeneous assembly of the Γ, Γ1, δ, ζ and η phases whose mechanical properties greatly differ from each other. Thermal strains resulting from large differences between thermal expansion coefficients are partially relaxed by the formation of a crack network. In order to model this phenomenon, initial hardness, thermal expansion coefficient αi and toughness (KIC)...
متن کاملDynamics of cracking in drying colloidal sheets.
Colloidal dispersions are known to display a fascinating network of cracks on drying. We probe the fracture mechanics of free-standing films of aqueous polymer-particle dispersions. Thin films of the dispersion are cast between a pair of plain steel wires and allowed to dry under ambient conditions. The strain induced on the particle network during drying is relieved by cracking. The stress whi...
متن کاملEffect of Aluminum on Microstructure and Thickness of Galvanized Layers on Low Carbon silicon-Free Steel
In hot dip galvanizing, several parameters such as chemical composition of coating bath, immersion time and surface roughness of specimens could affect microstructure and properties of coating. In this article, the effect of aluminum content, immersion time and surface roughness on structure and properties of alloy layers have been investigated. Specimens of low carbon silicon-free steel with d...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Textures and Microstructures
سال: 1995
ISSN: 0730-3300,1029-4961
DOI: 10.1155/tsm.23.131