Crack healing in cross-ply composites observed by dynamic mechanical analysis

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Interlaminar fatigue crack growth of cross-ply composites under thermal cycles

The fatigue growth of a fiber reinforced composite laminate was characterized under thermal cycling using a combined experimental and computational investigation. Twenty-four ply composite laminates (1⁄20 12=90 12 ) are fabricated with a pre-existing delamination, and subjected to thermal cycling in an environmental chamber. The large mismatch in the coefficients of thermal expansion is used to...

متن کامل

Mechanical Properties of Angle Ply Laminated Composites- A Review

The purpose of this study is to review many of the available guidelines for Polymer composite materials. Guide lines for failure mode, laminates orientation, winding angle, water absorption, as they strongly influence the mechanical properties of composite materials. The present review is focused on composite laminates made of glass, carbon, graphite, hybrid and natural fiber composites, since ...

متن کامل

Subsonic and Intersonic Dynamic Crack Growth in Unidirectional Composites

Some recent experimental observations of highly dynamic crack growth events in thick unidirectional graphite fiber-reinforced epoxy matrix composite plates are presented. The composite plates were symmetrically (mode-I) and asymmetrically (mode-II) loaded in a one-point bend configuration with an edge pre-notch machined in the fiber direction. The lateral shearing interferometric technique of c...

متن کامل

Dynamic Mechanical Analysis of Compatibilizer Effect on the Mechanical Properties of Wood Flour-High-Density Polyethylene Composites

In this study, effect of MAPE (maleic anhydride polyethylene) as the compatibilizer on the mechanical properties of wood-flour polyethylene composites has been investigated by using Dynamic Mechanical Analysis (DMA). Composites were made at 25% and 50% by weight fiber contents and 1% and 2% compatibilizer respectively. Controls were also made at the same fiber contents without the compatibilize...

متن کامل

Effective Crack Control of Concrete by Self-Healing of Cementitious Composites Using Synthetic Fiber

Although concrete is one of the most widely used construction materials, it is characterized by substantially low tensile strength in comparison to its compression strength, and the occurrence of cracks is unavoidable. In addition, cracks progress due to environmental conditions including damage by freezing, neutralization, and salt, etc. Moreover, detrimental damage can occur in concrete struc...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Mechanics and Physics of Solids

سال: 2015

ISSN: 0022-5096

DOI: 10.1016/j.jmps.2014.11.006