Crack Growth Analysis in Weld-Heat Affected Zone Using S-Version FEM
نویسندگان
چکیده
منابع مشابه
Heat Affected Zone in Surfacing Chromium Ledeburitic Steel
Repair welding is not used enough in the industry 1 . One of the reasons for this lies in the insufficient and unrealiable knowledge in many segments of this area. A very important part is having appropriate knowledge of metallurgical processes in heating of the base material 2-4 . Unsuitable heating deteriorates the microstructure as it reduces toughness and fracture behaviour of the weld 5 . ...
متن کاملA Cohesive Zone Model for Crack Growth Simulation in AISI 304 Steel
Stable ductile crack growth in 3 mm thick AISI 304 stainless steel specimens has been investigated experimentally and numerically. Multi-linear Isotropic Hardening method coupled with the Von-Mises yield criterion was adopted for modeling elasto-plastic behavior of the material. Mode-I CT fracture specimens have been tested to generate experimental load-displacement-crack growth data during sta...
متن کاملStudy Of Thermally Induced Residual Stresses For Stainless Steel Grade Using GMAW Process
Welding is a reliable and effective metal fabrication process which is widely used in industries. High heating at a one location during welding and further rapid cooling generates residual stress and distortion in the weld and base metal. In last few decades various research efforts have been directed towards the control of welding process parameter aiming at reducing residual stress and distor...
متن کاملEvaluation of metal weld-zone by using Poisson’s ratio distribution
Poisson’s ratio has not received much attention because of its narrow range of measured values and difficulties in measurement. In previous work, genuine non-destructive evaluation method of characterizing weld-zone using Poisson’s ratio distribution was proposed. The method was to use immersion ultrasonic testing for measuring longitudinal and transverse wave speeds simultaneously. In present ...
متن کاملMechanical Characterization of the Heat Affected Zone of Gold Wirebonds Using Nanoindentation
Abstrac t -With increasing miniaturization in microelectronics the wirebonds used in IC packages are witnessing a thrust towards fine pitch wirebonding. To have a precise control over loop height of the wirebond for fine pitch wirebonding, it is imperative to do mechanical characterization of the wirebond. The present work studies the mechanical properties of gold wire and wirebond using nanoin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers Series A
سال: 2009
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.75.1381