Corrosion Test of Concrete in Beppu Hot Spring
نویسندگان
چکیده
منابع مشابه
Corrosion of Reinforcing Bars in Concrete
The causes and mechanisms of corrosion of reinforcing bars in concrete are described in terms of the practical issues as well as the electrochemistry. The parameters affecting corrosion are (i) the ingress of aggressive species, such as chlorides, which break down the protective film on the reinforcing bar and (ii) the amount of those species necessary to do so. The former is largely controlled...
متن کاملHot Corrosion in Gas Turbines
DURING COMBUSTION in the gas turbine, sulfur from the fuel reacts with sodium chloride from ingested air at elevated temperatures to form sodium sulfate. The sodium sulfate then deposits on the hot-section components, such as nozzle guide vanes and rotor blades, resulting in accelerated oxidation (or sulfidation) attack. This is commonly referred to as “hot corrosion.” Sulfur in the fuel is gen...
متن کاملCorrosion of Concrete in Sea Water (RESEARCH NOTE)
Attack and disintegration of concrete structures under the influence of aggressive fluids, wet gases, etc. are understood as corrosion of concrete. The corrosion of concrete is a chemical, colloidchemical process, yet often a physico-chemical one, while that of reinforced concrete supported oil platforms are subjected to marine environment in the Persian Gulf and therefore corroded. In the pres...
متن کاملHot Spring Metagenomics
Hot springs have been investigated since the XIX century, but isolation and examination of their thermophilic microbial inhabitants did not start until the 1950s. Many thermophilic microorganisms and their viruses have since been discovered, although the real complexity of thermal communities was envisaged when research based on PCR amplification of the 16S rRNA genes arose. Thereafter, the pos...
متن کاملThe Non-Destructive Test of Steel Corrosion in Reinforced Concrete Bridges Using a Micro-Magnetic Sensor
This paper presents a non-destructive test method for steel corrosion in reinforced concrete bridges by using a 3-dimensional digital micro-magnetic sensor to detect and analyze the self-magnetic field leakage from corroded reinforced concrete. The setup of the magnetic scanning device and the measurement mode of the micro-magnetic sensor are introduced. The numerical analysis model is also bui...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Concrete Journal
سال: 1978
ISSN: 0387-1061
DOI: 10.3151/coj1975.16.11_10