Corrosion Studies of Reactor Materials by High Temperature and High Pressure Water Loop, (III)
نویسندگان
چکیده
منابع مشابه
Considerations of Well Cementing Materials in High-Pressure, High-Temperature Conditions (RESEARCH NOTE)
As worldwide demand of hydrocarbon is growing fast, the oil and gas companies have been forced to explore reservoirs with more hostile conditions, such as high-pressure, high-temperature conditions. Improved technology, material selection and testing procedures are required to overcome the common problems in these conditions. One of the main phases of well construction is cementing job. Appropr...
متن کاملNitrogen and Water in High Temperature Corrosion
Service life-time of alloys used in high temperature applications is often limited by corrosion. FeCrAl(Re) alloys are partially designed to form a protective α-alumina oxide scale at elevated temperatures in order to mitigate further oxidation. The scale growth commonly follows a parabolic rate law, which under a Wagnerian setting depends on transport of charged species; ions, vacancies and el...
متن کاملHIGH TEMPERATURE ELASTIC PROPERTIES OF REFRACTORY MATERIALS
Abstract: A pulse-echo technique, based on ultrasonic "long-bar" mode (LBM) velocity measurements, working up to 1700°C is described. Magnetostrictive transducers and ultrasonic lines used in a 40-85 kHz frequency range are detailed. The conditions of choice of fundamental parameters (frequency, line geometry, sample size) are discussed in relation with the nature and the microstructure of ...
متن کاملA new scanning tunneling microscope reactor used for high-pressure and high-temperature catalysis studies.
We present the design and performance of a homebuilt high-pressure and high-temperature reactor equipped with a high-resolution scanning tunneling microscope (STM) for catalytic studies. In this design, the STM body, sample, and tip are placed in a small high pressure reactor ( approximately 19 cm(3)) located within an ultrahigh vacuum (UHV) chamber. A sealable port on the wall of the reactor s...
متن کاملAdvanced Computational Modeling for Growing III-V Materials in a High-Pressure Chemical Vapor-Deposition Reactor
A numerical model was developed to simulate vapor deposition in high-pressure chemical vapor-deposition reactors, under different conditions of pressure, temperature, and flow rates. The model solved for steady-state gas-phase and heterogeneous chemical kinetic equations coupled with fluid dynamic equations within a three-dimensional grid simulating the actual reactor. The study was applied to ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Atomic Energy Society of Japan / Atomic Energy Society of Japan
سال: 1965
ISSN: 0004-7120
DOI: 10.3327/jaesj.7.148