Corrosion resistant bimetallic pipe manufactured by HIP and hot extrusion(HHE) process.
نویسندگان
چکیده
منابع مشابه
Monitoring Pipe-Wall Corrosion Rate by Ultrasonic Technique
thickness and corrosion/erosion rate. In this thesis, a combination of signal processing techniques are used to estimate the corrosion rate estimates based on MBE. Corrosion rate is estimated based on ultrasonic pipe wall thickness data is collected over a short period of time using MBE model. This technique is based on data collected from the speedometer applied for thinning and both indicate ...
متن کاملCorrosion and scaling in Bandar Abbas Pipe water network
Introduction: Scaling and corrosion is one the most important indices in water quality evaluation. Occurrence of scaling or corrosion may create disorder in economy of water and wastewater industry. In addition, corrosion produces by - products in water leading to health problem and reduction of water pipe life-time. In this study, the condition of scaling and corrosion in Bandar Abbas wa...
متن کاملHot Corrosion in Gas Turbines
DURING COMBUSTION in the gas turbine, sulfur from the fuel reacts with sodium chloride from ingested air at elevated temperatures to form sodium sulfate. The sodium sulfate then deposits on the hot-section components, such as nozzle guide vanes and rotor blades, resulting in accelerated oxidation (or sulfidation) attack. This is commonly referred to as “hot corrosion.” Sulfur in the fuel is gen...
متن کاملCorrosion Resistant Alloys for Deep Offshore Drilling by High Density Infrared Fusion Process
Corrosion of offshore oil and gas pipelines is an important problem that can generate catastrophic failures if not adequately managed. The issues are more important and critical for deepwater pipelines due to complexity of the designs and also due to difficulty in inspection, monitoring, and repair. Pipelines exposed to these severely corrosive environments require the use of corrosion resistan...
متن کاملCorrosion of modular hip prostheses.
Nine uncemented hip prostheses of modular design were revised because of late infection (2 cases), femoral stem loosening or fracture (2), loosening of threaded cups (3) and protrusion of bipolar cups (2). At surgery we found tissue discoloration and macroscopic corrosion in four of the nine prostheses, located at the head-neck junction. Histological examination in most cases showed extensive n...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 1991
ISSN: 0915-1559
DOI: 10.2355/isijinternational.31.233