Corrosion properties of CVD grown Ti(C,N) coatings in 3.5 wt-% NaCl environment

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An Investigation of Tribological Properties of CN and TiCN Coatings

Today the tool industry on a worldwide basis uses hard, wear-resistant, and low-friction coatings produced by different processes such as electrochemical or electroless methods, spray technologies, thermochemical, chemical-vapor deposition (CVD), and physical vapor deposition (PVD). In the current work, two different coatings, nitrocarburized (CN) and titanium carbonitride (TiCN) on M2-grade to...

متن کامل

Hot Corrosion of Ti-Based Intermetallics with Coatings in NaCl+ (Na,K)2SO4 Melts at 750oC

In this study, the hot corrosion of TiAl, TiAlNb, and Ti3AlNb intermetallics with or without enamel coating and sputtered TiAlCr coating in (Na, K)2SO4 + NaCl melts at 750oC is investigated. The interfacial reaction between enamel and those alloys during hot corrosion has also been evaluated. The results indicate that severe corrosion of bare alloys occurs due to the self catalysis chlorination...

متن کامل

Interface properties of CVD grown graphene transferred onto MoS2(0001).

Heterostructures of dissimilar 2D materials are potential building blocks for novel materials and may enable the formation of new (photo)electronic device architectures. Previous work mainly focused on supporting graphene on insulating wide-band gap materials, such as hex-BN and mica. Here we investigate the interface between zero-band gap semiconductor graphene and band-gap semiconductor MoS2 ...

متن کامل

Comparison of Medium Manganese Steel and Q345 Steel on Corrosion Behavior in a 3.5 wt % NaCl Solution

A cyclic wet/dry accelerated corrosion test was used to compare the corrosion behavior of medium-Mn steel and Q345 steel. In terms of scanning electron microscope (SEM), using X-ray diffraction (XRD), electron probe microanalysis (EPMA), X-ray photoelectron spectroscopy (XPS), and analysis of the corrosion process, the results showed that the medium-Mn steel did not exhibit higher corrosion res...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Corrosion Engineering, Science and Technology

سال: 2018

ISSN: 1478-422X,1743-2782

DOI: 10.1080/1478422x.2018.1467150