Corrosion of titanium alloys in pressurized water at 300 °C and 15 MPa
نویسندگان
چکیده
منابع مشابه
Diffusion in supercooled water to 300 MPa.
Measurements of the self-diffusion coefficient in supercooled ~ater to 300 MPa are reported. Translational diffusion in liquid water at 243 K is enhanced by 60% when the pressure is increased from 0. 1 to 150 MPa, and rotational diffusion is enhanced by almost 250% between 0. 1 and 250 MPa. These striking anomalies are interpreted in terms of the proximity of a conjectured line of spinodal-like...
متن کاملIn vitro corrosion behaviour of titanium alloys without vanadium
The corrosion behaviour of three new non-toxic titanium alloys for use as biomaterials has been investigated. The corrosion current densities of these Ti alloys have low values, indicating a passive state that is stable with time. These values were calculated by using both direct and alternate current methods. The comparison with Ti–6Al–4V, widely used as biomaterial, shows slightly lower corro...
متن کاملCorrosion Properties of F82H in Flowing High Temperature Pressurized Water
This work reports the effects of water flow and dissolved oxygen (DO) on corrosion behavior of reduced activation ferritic/martensitic steel, F82H. The corrosion tests were performed in high temperature pressurized water by using a test apparatus for rotated disk sample. All of specimens showed weight gains after static corrosion tests up to 500 h. However, the rotated disk showed weight losses...
متن کاملCorrosion behavior of pure titanium and titanium alloys in fluoride-containing solutions.
The effects of fluoride concentrations and pH on the corrosion behavior of pure titanium, Ti-6Al-4V, Ti-6Al-7Nb alloys and a new Ti alloy adding palladium, which is expected to promote a repassivation of Ti were examined by anodic polarization and corrosion potential measurements. The amount of dissolved Ti was analyzed by inductively coupled plasma mass spectroscopy. The surface of the specime...
متن کاملNickel-Titanium Alloys: Corrosion “Proof” Alloys for Space Bearing, Components and Mechanism Applications
An intermetallic nickel-titanium alloy, 60NiTi (60wt%Ni, 40wt%Ti), is shown to be a promising candidate tribological material for space mechanisms. 60NiTi offers a broad combination of physical properties that make it unique among bearing materials. 60NiTi is hard, electrically conductive, highly corrosion resistant, readily machined prior to final heat treatment, and is non-magnetic. Despite i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2020
ISSN: 2261-236X
DOI: 10.1051/matecconf/202032106006