Corrosion Behaviour of Aluminum Alloy AA7075-T651

CORROSION BEHAVIOUR OF Al-Li-Cu-Mg ALLOY 8090-T651

Corrosion Behaviour of NIMONIC-90 Alloy

Investigations were conducted on hot corrosion of Nickel base, NIMONIC-90 at 675°C and 725°C. The tests were carried out on small test coupons coated with a chemical containing Sodium sulphate and Sodium Vanadate which is representative of the corrosive deposit that usually forms during service in the coal fired boiler and the likes operating in marine atmospheres. Corrosion rates were measured...

Application of the GTN Model in Ductile Fracture Prediction of 7075-T651 Aluminum Alloy

In this paper the capability of Gurson-Tvergaard-Needleman (GTN) model in the prediction of ductile damage in 7075-T651 aluminum alloy is investigated. For this purpose, three types of specimens were tested: Standard tensile bars, Round notched bar (RNB) specimens and compact tension (C(T)) specimens. Standard tensile bar tests were used to obtain the mechanical properties of the material and t...

Three Dimensional Microstructures: Statistical Analysis of Second Phase Particles in AA7075-T651

1. Abstract. This paper describes some aspects of reconstruction of microstructures in three dimensions. A distinction is drawn between tomographic approaches that seek to characterize specific volumes of material, either with or without diffraction, and statistical approaches that focus on particular aspects of microstructure. A specific example of the application of the statistical approach i...

Surface Finish and Residual Stresses Induced by Orthogonal Dry Machining of AA7075-T651

The surface finish was extensively studied in usual machining processes (turning, milling, and drilling). For these processes, the surface finish is strongly influenced by the cutting feed and the tool nose radius. However, a basic understanding of tool/surface finish interaction and residual stress generation has been lacking. This paper aims to investigate the surface finish and residual stre...