Corrosion behavior of Mg-(0~6)%Zn Casting Alloys in 1M NaCl Solution
نویسندگان
چکیده
منابع مشابه
Corrosion Behavior of Novel Mg-9Li-7Al-1Sn and Mg-9Li-5Al-3Sn-1Zn Alloys in NaCl Aqueous Solution
Corrosion behavior of two multiphase Mg-Li-Al-based alloys in 0.6 M NaCl aqueous solution is investigated by hydrogen gas evolution measurement and electrochemical test. This paper reports, for the first time, the comparison of hydrogen evolution and Tafel extrapolation results of Mg-Li-Al-based alloys. The corrosion rate of Mg-9Li-7Al-1Sn is observed to be reasonably higher when compared to th...
متن کاملThe Electrochemical Behavior of Al Alloys in NaCl Solution in the Presence of Pyrazole Derivative
This paper studies the corrosion inhibition of Al-Mg alloy system in 0.5 mol/dm3 NaCl solution in the presence of pyrazole derivative using potentiodynamic polarization and linear polarization method. The inhibition efficiency as a function of concentration and temperature was investigated. From the polarization curves, it can be concluded that the pyrazole derivative be...
متن کاملCorrosion Behavior of Solution- Annealed CoCrMo Medical Implant Alloys
Corrosion behavior of solution annealed high-carbon and low-carbon CoCrMo wrought alloy, commonly used in medical joint implants, was investigated. The surface passivation properties remained similar with and without the various solution anneal conditions, while the rate of corrosion was lower for solution annealed high-carbon CoCrMo. Corrosion was found to target phase boundaries and certain g...
متن کامل[Initial corrosion of dental casting alloys in the oral environment].
In order to study the initial corrosive changes of dental casting alloys in the mouth, the condition and composition of the proximal surface of the class II inlay were analyzed by the scanning electron microscope (SEM) and the electron probe microanalyser (EPMA). These analyses on the same small areas of the proximal surface were carried out every week for four weeks. The results were compared ...
متن کاملThe Role of Mg2Si in the Corrosion Behavior of Al-Si-Mg Alloys for Pressureless Infiltration
The role of Mg2Si in the electrochemical behavior of Al-Si-Mg aluminum alloys has been studied using four experimental aluminum alloys with variations in the Si/Mg molar ratio (A1-0.12, A2-0.49, A3-0.89, A4-1.05), in neutral aerated 0.1M NaCl solutions. Accordingly, the corrosion potential in open circuit (Eoc) and polarization resistance (Rp) were measured. Results show that the augment in Si/...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Korea Foundry Society
سال: 2016
ISSN: 1598-706X
DOI: 10.7777/jkfs.2016.36.4.117