Correlation of rolling condition, microstructure, and low-temperature toughness of X70 pipeline steels
نویسندگان
چکیده
منابع مشابه
The effects of chemical composition variations on microstructure and mechanical properties of nanostructured, low temperature bainitic steels
Bainitic transformation at low transformation temperatures leads to a microstructure involving fine plates of bainitic ferrite and thin films of retained austenite. This microstructure has shown ultimate tensile strength of about 2.2 GPa, noticeable uniform elongation in the range of 5 to 30%, hardness values of about 600 to 670 HV and impact toughness in the range of 30 to 40 MPa m1/2. With ca...
متن کاملMicrostructure Evolution of HSLA Pipeline Steels after Hot Uniaxial Compression
The mechanical properties of the high-strength low-alloy pipeline steels were mainly controlled by the subsequent phase transformations after rolling. The influence of hot uniaxial compression on the phase transformation of acicular ferrite was explored by viewing of the deformation degree, the deformation temperature, and the strain rate. The results show that the increase of deformation amoun...
متن کاملEffect or Inoculation on Microstructure and Properties of Low C-Mn and Low Alloy Steels
Effect of the addition of various inoculants on the morphology and mechanical properties of low C-Mn and low alloy steel samples is studied by thermal and mechanical processing of the samples after solidification. According to the results obtained from metallographic studies with the electron microscope and microanalysis with x-rays, the distribution of inoculating agents in the steel matrix is...
متن کاملEFFECT OF FINISH ROLLING TEMPERATURE ON MICROSTRUCTURE,TEXTURE AND PLANAR ANISOTROPY IN ALUMINUM ALLOY AA3004 SHEETS
AA3004 alloy is widely used in can making. The major concern in the production of canbodies is earing, which develop by high planar anisotropy of rolled sheet. Balance ofrecrystallisation and rolling textures together with a uniform and fine grain microstructure canminimize the earing. The effects of finish rolling temperature (FRT) on planar anisotropy,microstructure, texture development and m...
متن کاملthe effects of chemical composition variations on microstructure and mechanical properties of nanostructured, low temperature bainitic steels
bainitic transformation at low transformation temperatures leads to a microstructure involving fine plates of bainitic ferrite and thin films of retained austenite. this microstructure has shown ultimate tensile strength of about 2.2 gpa, noticeable uniform elongation in the range of 5 to 30%, hardness values of about 600 to 670 hv and impact toughness in the range of 30 to 40 mpa m1/2. with ca...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgical and Materials Transactions A
سال: 2005
ISSN: 1073-5623,1543-1940
DOI: 10.1007/s11661-005-0043-1