Correlation between Molding Conditions and Foam Morphology in Microcellular Injection Molding
نویسندگان
چکیده
منابع مشابه
Precision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملCeramic Injection Molding
Powder injection molding (PIM), which encompasses metal injection molding (MIM) and ceramic injection molding (CIM), is a net-shaping process which enables large scale production of complex-shaped components for use in a diverse range of industries. It combines plastic injection molding techniques and performance attributes of ceramic and metal powders. Ceramic injection molding (CIM) uses cera...
متن کاملDynamic of Taking out Molding Parts at Injection Molding
E. Ragan, J. Dobránsky, P. Baron, M. Kočiško, J. Svetlík, Technical University in Košice, Slovakia Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it. Task of this contribution is to theoretically describe a transport of molding at taking out after injection molding in relation o...
متن کاملLIMS - Liquid Injection Molding Simulation
design and analysis software solutions for composite structures for more than two decades. The software is continuously upgraded to reflect new research findings as well as to capitalize on advances in computing technology. Software applications such as CDS2.0, LIMS and MAT162 are used extensively by researchers at UD-CCM and industrial sponsors to predict material properties and behavior durin...
متن کاملPrimary Experimental Study on Microcellular Injection Molding Using Newly-developed Equipment
Microcellular injection molding using supercritical fluid (SCF) as blowing agent attracts more and more interests. There are still many difficulties in microcellular injection molding, such as decreasing equipment cost, controlling cellular morphology, and increasing feasibility. In this work, primary microcellular injection molding experiments were carried out on newly-developed equipment, whi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Seikei-Kakou
سال: 2009
ISSN: 0915-4027,1883-7417
DOI: 10.4325/seikeikakou.21.633