Correction of beam-steering effects in low-velocity superconducting quarter-wave cavities
نویسندگان
چکیده
منابع مشابه
Superconducting Spoke Cavities For High-Velocity Applications
This Article is brought to you for free and open access by the Physics at ODU Digital Commons. It has been accepted for inclusion in Physics Faculty Publications by an authorized administrator of ODU Digital Commons. For more information, please contact [email protected]. Repository Citation Hopper, C. S. and Delayen, J. R., "Superconducting Spoke Cavities For High-Velocity Applications" (...
متن کاملMedium Field Q-slope Studies in Quarter Wave Cavities
The quality factor of superconducting radio-frequency niobium cavities decreases with the applied RF field in the medium field range. The medium field Q-slope effect has been investigated by many authors but models, most commonly including thermal feedback, do not fully explain experimental evidence. In this contribution we analyze medium field Q-slope data measured on ISAC-II low beta quarter ...
متن کاملSpectra of Beam Induced Fields in Cesr Superconducting Cavities
Frequency spectra of the fields induced by beam in four superconducting accelerating cavities of CESR collider are measured and analyzed. Resonance frequencies and Q values of cavity higher order modes are extracted from these measurements. Most of higher order modes have Q values less than 2000. However, few of them have higher Q. The results are compared with computer calculations of higher o...
متن کاملBeam Dynamics Studies on the Isac Ii Superconducting Linac
The ISAC II superconducting linac is presently in the beam commissioning phase. The linac lattice consists of modules of four quarter wave cavities and one superconducting solenoid. At the moment five cryomodules (indicated as medium beta section) are installed. Beam steerers between cryomodules compensate for steering effects due to misalignments in the solenoids. Beam dynamics aspects of lina...
متن کاملBunch Energy Loss in Cavities: Dependence on Beam Velocity
Proton or H linacs accelerate particles through the wide range of the particle velocities. For intense beams, and especially when superconducting cavities are used, a detailed knowledge about how the beam energy loss depends on the beam velocity = v=c, and what part of the lost energy remains in the cavity, is required to calculate the cavity heat load. Using a frequency-domain approach, we cal...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review Special Topics - Accelerators and Beams
سال: 2001
ISSN: 1098-4402
DOI: 10.1103/physrevstab.4.110101