Correction Factor for Power Gain in Antenna Arrays
نویسندگان
چکیده
منابع مشابه
Modified Bi-directional AC/DC Power Converter with Power Factor Correction
Most existing power converters and industrial motor drive systems draw non-sinusoidal currents from the supply. Non-sinusoidal currents contained harm harmonics disturb the power supply which it causes serious concern for reliability. Other equipments that use the same power supply are adversely affected. This paper suggests the operation and performance of a new modified AC/DC converter that ...
متن کاملSingle Stage Techniques for Power Factor Correction
Medium and high power switch mode power supplies SMPS (>500W) used in telecommunications stations are normally based on the full-bridge DC-DC converter with isolation transformer. According to the transistors states, the full-bridge converter allows four different switching sates which can be used to control the output voltage of the SMPS, and to perform the power factor corrector (PFC) functio...
متن کاملDigital Control For Power Factor Correction
This thesis focuses on the study, implementation and improvement of a digital controller for a power factor correction (PFC) converter. The development of the telecommunications industry and the Internet demands reliable, cost-effective and intelligent power. Nowadays, the telecommunication power systems have output current of up to several kiloamperes, consisting of tens of modules. The high-e...
متن کاملPower Control and Antenna Gain Optimization during Wimax Handover
Wireless systems have recently been becoming faster and more intelligent. However the high speed access and intelligence make the power consumption of wireless systems high. In the WiMAX system, the MS transmission power is controlled in order to avoid exceeding the BS’s total receiving power from an antenna. Conventional wireless network design has long used base site sectorization and single,...
متن کاملImproved Parallel Boost Power Converter for Power Factor Correction
The main objective of the study is to analysis and design parallel boost power converter for power factor correction using an active filtering approach by implementing single-phase soft-switching technique with an active snubber circuit. Zero voltage transition to turn ON and zero current transition to turn OFF is implemented by the active snubber circuit for the main switches with no any furth...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Communications, Network and System Sciences
سال: 2018
ISSN: 1913-3715,1913-3723
DOI: 10.4236/ijcns.2018.113004