منابع مشابه
Evaluation for Tensile Performance of Recently Developed FRP Hybrid Bars
This paper deals with an experimental study on the tensile performance of recently developed “FRP Hybrid Bars” by authors. The objective of this study is to investigate tensile strength of FRP Hybrid Bars and to overcome the shortcomings of the FRP material with its low elastic modulus. This uses the concept of material hybridization to increase elastic modulus to be used in concrete structures...
متن کاملImproved specimen recovery in tensile split Hopkinson bar.
This paper presents an improved specimen recovery method for the tensile split Hopkinson bar (TSHB) technique. The method is based on the trapping of residual stress waves with the use of momentum trap bars. As is well known, successful momentum trapping in TSHB is highly sensitive to experimental uncertainties, especially on the incident bar side of the set-up. However, as is demonstrated in t...
متن کاملCritical Specimen Sizes for Tensile-Shear Testing of Steel Sheets
Tensile-shear testing results are influenced not only by the quality of spot welds, but also by the dimensions of testing specimens. Experimental and numerical studies have been conducted on determining critical sizes for tensileshear testing of resistance spot welded specimens. Statistical methods have been employed, from planning stages to the analysis of results, for the purposes of getting ...
متن کاملThermomechanical Studies in Glass/Epoxy Composite Specimen during Tensile Loading
This paper presents the results of thermo-mechanical characterization of Glass/Epoxy composite specimens using Infrared Thermography technique. The specimens used for the study were fabricated in-house with three different lay-up sequences and tested on a servo hydraulic machine under uni-axial loading. Infrared Camera was used for on-line monitoring surface temperature changes of composite spe...
متن کاملInfluence of Specimen Preparation and Specimen Size on the Transverse Tensile Strength and Scatter of Glass Epoxy Laminates
The influence of specimen polishing, specimen configuration, and specimen size on the transverse tension strength of two glass epoxy materials loaded in three and four point bending was evaluated. Polishing machined edges, and/or tension side failure surfaces, was detrimental to specimen strength characterization instead of yielding a higher, more accurate, strength as a result of removing inhe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2020
ISSN: 1757-899X
DOI: 10.1088/1757-899x/747/1/012136