Cooling cycle test of DC superconducting power transmission cable
نویسندگان
چکیده
منابع مشابه
Power Cable Protection in Transmission System
Power cable is widely used in Extra High Voltage (EHV), High Voltage (HV) transmission, Medium Voltage (MV) sub-transmission, and MV / Low Voltage (LV) distribution applications. Basically, the protection principles used for cable are similar with the ones for overhead transmission line. However, the inherent characteristics of cables make its fault behavior more complicate than that of transmi...
متن کاملReduced-Cable Smart motors Using DC Power Line Communication
A novel servomotor design that is powered and controlled through only one wire is presented in this paper. A traditional servomotor needs both a power cable and a control cable connecting the motor to a control amplifier. Cables are bulky, heavy, and expensive and, more importantly, difficult to install and maintain in many applications. Particularly for multi-axis applications, like robots and...
متن کاملPower Upgrading of Transmission Line by Combining AC–DC Transmission
Long extra high voltage (EHV) ac lines cannot be loaded to their thermal limits in order to keep sufficient margin against transient instability. With the scheme proposed in this project, it is possible to load these lines very close to their thermal limits. The conductors are allowed to carry usual ac along with dc superimposed on it. The added dc power flow does not cause any transient instab...
متن کاملTheoretical analysis of a novel combined cooling, heating, and power (CCHP) cycle
This study presents a theoretical analysis of a new combined cooling, heating, and power cycle by the novel integration of an organic Rankine cycle (ORC), an ejector refrigeration cycle (ERC), and a heat pump cycle (HPC) for producing cooling output, heating output, and power output simultaneously. Three different working fluids—namely R113, isobutane, and R141b—have been used in power, ref...
متن کاملA Cycle-Based Formulation and Valid Inequalities for DC Power Transmission Problems with Switching
It is well-known that optimizing network topology by switching on and off transmission lines improves the efficiency of power delivery in electrical networks. In fact, the USA Energy Policy Act of 2005 (Section 1223) states that the U.S. should “encourage, as appropriate, the deployment of advanced transmission technologies” including “optimized transmission line configurations.” As such, many ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2010
ISSN: 1742-6596
DOI: 10.1088/1742-6596/234/3/032019