Cooling Air Inlet and Exit Geometries on Aircraft Engine Installations
نویسندگان
چکیده
منابع مشابه
Air-Cooling Effects of Fins on a Motorcycle Engine∗
Effects of the number of fins, fin pitch and wind velocity on air-cooling were investigated using experimental cylinders for an air-cooled engine of a motorcycle. Experimental cylinders that had a various number of fins and fin pitches were tested in a wind tunnel. Then the temperature inside of the cylinder, on the surface of the fins and in the space between the fins was measured. Results ind...
متن کاملTechno-Economic Assessment of Different Inlet Air Cooling Systems in Warm Dry & Wet Climate Stations
Performance of a gas turbine mainly depends on the inlet air temperature. The power output of a gas turbine depends on the flow of mass through it. This is precisely the reason why on hot days, when air is less dense, power output falls. The objective here is to assess the advanced systems applied in reducing the gas turbine intake air temperature and examine the merits from integration of the ...
متن کاملDrag and Propulsive Characteristics of Air-cooled Engine-nacelle Installations for L4rge Airplanes
An investigation is in progress in the h?ACA @i!-scale wind tunrwl to dktermine the drag and the propukioe e$kienqt of nacelle-propehr arrangernentcjiw a large range ofnacelle m“ae. In cmtrad with the usual i%ti unlh a tingle nacelle, the~e w were conducted with nacelk-propelkr inctafla$ioncon a large model of a fourengine airplane. Data are presented on & $rst part of the ince8tigation, cowm”n...
متن کاملEnergy and Second Law of Thermodynamics Analysis of Shower Cooling Tower with Variation in Inlet Air Temperature
A shower cooling tower (SCT) operates without fill because of salt decomposition on the fill that leads to deterioration of conventional cooling tower performance. This study presents a two-dimensional mathematical model for energy and exergy analysis of multi-diameter droplets and air interaction along with the height of the forced draft SCT, to predict the exit condition of water droplet for ...
متن کاملIntegration of steam injection and inlet air cooling for a gas turbine generation system
The temperature of exhaust gases from simple cycle gas turbine generation sets (GENSETs) is usually very high (around 500 C), and a heat recovery steam generator (HRSG) is often used to recover the energy from the exhaust gases and generate steam. The generated steams can be either used for many useful processes (heating, drying, separation etc.) or used back in the power generation system for ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Aircraft
سال: 1982
ISSN: 0021-8669,1533-3868
DOI: 10.2514/3.57425