Convective heat transfer coefficient for indoor forced convection drying of vermicelli

نویسندگان

چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Heat Transfer Study of Perforated Fin under Forced Convection

Fins are protrusions on a heat transfer surface to augment heat transfer rate from it. The increase in area exposed to convection in case of finned surfaces results in increased heat transfer rate. In this study heat transfer characteristics of a pin fin with perforation is numerically analyzed. A pin fin is fabricated and experiments are done under forced convection conditions. The experimenta...

متن کامل

Evaluation of convective mass transfer coefficient during drying of jaggery

In this paper an attempt is made to evaluate the convective mass transfer coefficient during drying of jaggery in a controlled environment. In this method, different masses of jaggery were used. The jaggery was dried in the roof type even span greenhouse with a floor area of 1.2x0.8 m in natural and forced convection mode at atmospheric pressure till it attained almost no variation in mass. The...

متن کامل

Analysis of variance of nanofluid heat transfer data for forced convection in horizontal spirally coiled tubes

In the present study, an experimental study is carried out to investigate the effect of adding Al and Cu nanoparticles to the base fluid (water) on the heat transfer rate in a spirally coiled tube. The spirally coiled tube is fabricated from the straight copper tube with the inner and outer coil diameters of 100 and 420 mm, respectively. The experiments have been done for water and two types of...

متن کامل

Experimental study of convective heat transfer coefficient of MgO nanofluid in a cylindrical microchannel heat sink

Convective heat transfer of MgO-water nanofluid in a microchannel heat sink is experimentally investigated in various concentrations of 0.01, 0.05, 0.1, and 0.6 wt%. The microchannel consisted of 48 parallel rectangular cross section channels with the height of 800 µm, width of 524 µm and length of 52 mm. A well stability duration (ca. 1 month) was resulted by a 180 min ultra-sonication of the ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IOSR Journal of Engineering

سال: 2012

ISSN: 2278-8719,2250-3021

DOI: 10.9790/3021-026112821290