CONTROL RECONFIGURATION IN NETWORKED CONTROL SYSTEM
نویسندگان
چکیده
منابع مشابه
Control reconfiguration in networked control system
In the research on the networked control systems (NCS) the performance of the control system is assumed to be affected by network induced parameters such as delays, jitters, packet losses, link failures. In this paper a reconfiguration of the network control is presented. The upper bound delay of the transmission time of a packet is monitored with the network calculus based algorithm. A modific...
متن کاملReliability of Networked Control System Using the Network Reconfiguration Strategy
This paper presents results of modelling and analysis of Network Control Systems (NCS) using the reconfiguration strategies in case of individual networks faults. In general the NCS as all systems follows its mission which should be accomplished with guarantee. The system mission can be disturbed or interrupted by failures which occur with some probability. A primary requirement in order to ben...
متن کاملRobust Model for Networked Control System with Packet Loss
The Networked Control System in modern control widely uses to decrease the implementation cost and increasing the performance. NCS in addition to its advantages is inevitable. Nevertheless they suffer of some limitations and deficiencies. Packet loss is one of the main limitations which affect the control system in different conditions and finally may lead to system instability. For this reason...
متن کاملemittance control in high power linacs
چکیده این پایان نامه به بررسی اثر سیم پیچ مغناطیسی و کاوه یِ خوشه گر با بسامد رادیویی بر هاله و بیرونگراییِ باریکه هایِ پیوسته و خوشه ایِ ذرات باردار در شتابدهنده های خطیِ یونی، پروتونی با جریان بالا می پردازد و راه حل هایی برای بهینه نگهداشتن این کمیتها ارایه می دهد. بیرونگرایی یکی از کمیتهای اساسی باریکه هایِ ذرات باردار در شتابدهنده ها است که تاثیر قابل توجهی بر قیمت، هزینه و کاراییِ هر شتابدهند...
Modelling Vector Control System Reconfiguration
To apply run-time reconfiguration there is need for an appropriate model to understand reconfiguration. System on chip technology allowed the use of complex low gate/price new type of FPGA. Modelling reconfiguration and using Matlab tools is possible to simulate and rapid prototype vector control systems. The paper presents the reconfigurable models as introduced by Luk, Cheung, Shirazi and Ath...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IFAC Proceedings Volumes
سال: 2006
ISSN: 1474-6670
DOI: 10.3182/20060829-4-cn-2909.00052