Control of intermetallic nano-particles through annealing in duplex low density steel
نویسندگان
چکیده
منابع مشابه
Control of Formation of Intermetallic Compound in Dissimilar Joints Aluminum-steel
The elimination of the FexAly type phases was considered the solution to low ductility presented in aluminum-steel welded joints. Recently, the researches do not seek the suppression but the control of the thickness of these compounds. In this work, Al-Fe joints were manufactured by solid state and fusion welding, looking for controlling the formation of intermetallic comp...
متن کاملsynthesis of amido alkylnaphthols using nano-magnetic particles and surfactants
we used dbsa and nano-magnetic for the synthesis of amido alkylnaphtols.
15 صفحه اولDevelopment of Ultrafine Lamellar Ferrite and Austenite Duplex Structure in 0.2C5Mn Steel during ART-annealing
The microstructural evolution of Fe–0.2C–5Mn steel during intercritical annealing with holding time for up to 144 hours was examined by TEM and STEM. It was demonstrated by TEM that the martensite lath structure gradually transformed into a lamellar ferrite and austenite duplex structure. The partitioning of manganese from ferrite to austenite was found by STEM. Typical Kurdjumov-Sachs orientat...
متن کاملAn investigation on full annealing temperature and annealing twins’ Density in Fe-33Mn-3Si-2Al high-manganese steel
Twinning induced plasticity (TWIP) steels with high manganese percentage (17-35%), are mostly used in automotive bodies. Their microstructure at room temperature is austenitic, and due to the low stacking fault energy, major deformation mechanism in them is twinning inside austenite grains which leads to enhanced mechanical strength in the steel. Due to the important effect of heat treatment pr...
متن کاملLow–Alloy Duplex, Directly–Quenched Transformation–Induced Plasticity Steel
A duplex microstructure consisting of allotriomorphic ferrite and austenite at ambient temperature, has been produced in a low–alloy steel, by a simple heat treatment which involves intercritical annealing followed by quenching. The tensile properties obtained are good, with a total elongation of some 28% at an ultimate tensile strength approaching 900MPa. The form of the stress versus strain c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Letters
سال: 2017
ISSN: 0167-577X
DOI: 10.1016/j.matlet.2016.11.020