Control of hypersonic aerodynamic forces with surface blowing

Hypersonic Flow with Strong Blowing

A validation study is presented for a numerical code which calculates a two-dimensional steady-state solution for inviscid hypersonic flows in the presence of strong surface blowing. A higher-orde: Godunov-type finite-volume approach is used to discretize the inviscid Euler equations. Interface values of the state quantities are reconstructed nsing a monotone interpolation technique suggested b...

Comparison of Theodorsen’s Unsteady Aerodynamic Forces with Doublet Lattice Generalized Aerodynamic Forces

This paper identifies the unsteady aerodynamic forces and moments for a typical section contained in the NACA Report No. 496, “General Theory of Aerodynamic Instability and the Mechanism of Flutter,” by Theodore Theodorsen. These quantities are named Theodorsen’s aerodynamic forces (TAFs). The TAFs are compared to the generalized aerodynamic forces (GAFs) for a very high aspect ratio wing (AR =...

1 X - 33 Hypersonic Aerodynamic Characteristics

Lockheed Martin Skunk Works, under a cooperative agreement with NASA, will build and fly the X-33, a half-scale prototype of a rocket-based, single-stage-to-orbit (SSTO), reusable launch vehicle (RLV). A 0.007-scale model of the X-33 604B0002G configuration was tested in four hypersonic facilities at the NASA Langley Research Center to examine vehicle stability and control characteristics and t...

Parallel Computation in Hypersonic Aerodynamic Heating Problem

A parallel computational fluid dynamics code has been developed for the study of aerodynamic heating problem in hypersonic flows. The code employs the 3D Navier-Stokes equations as the basic governing equations to simulate the laminar hypersonic flow. The cell centered finite volume method based on structured grid is applied for spatial discretization. The AUSMPW+ scheme is used for the invisci...

Strip Blowing from a Wedge at Hypersonic Speeds