Constant-frequency control of quasi-resonant converters
نویسندگان
چکیده
منابع مشابه
Constant-Frequency Control of Quasi-Resonant Converten
An additional independent control needed to eliminate the undesirable variable switching frequency of quasi-resonant converters can be obtained if the output rectifier is replaced by an active switch. The concept is applicable to all classes of quasi-resonant converters. It is demonstrated that in addition to operation at constant switching frequency, selected classes of constant-frequency quas...
متن کاملOn Model Predictive Control of Quasi-Resonant converters
In this paper, different model predictive control synthesis frameworks are examined for DC–DC quasi-resonant converters in order to achieve stability and desired performance. The performances of model predictive control strategies which make use of different forms of linearized models are compared. These linear models are ranging from a simple fixed model, linearized about a reference steady st...
متن کاملeGaN® FETs in High Frequency Resonant Converters
Distributed power systems are prevalent in telecommunications, networking, and high-end server applications and generally utilize a 48 V bus voltage adopted from the telecom industry. From the 48 V bus, a number of isolated point of load (POL) converters power the end loads, with isolation being required for safety. The traditional distributed power architecture (DPA), shown in figure 1(a), use...
متن کاملTime-shift Control of LLC Resonant Converters
This paper describes a new control technique for resonant converters that outperforms the direct frequency control (DFC) method implemented in all today’s commercially available control ICs. When applied to LLC resonant converters, the resulting dynamic behavior is that of a low-Q second-order system or that of a first-order system, depending on the operating conditions. Thus closing the contro...
متن کاملSoft Switched Resonant Converters with Unsymmetrical Control
Using PSPICE a resonant dc-dc converters operating at constant frequency was simulated. The paper concentrates on the working of a half bridge topology employing ZVS techniques. The operation of converter with LC filter in the output is discussed. The design and fabrication was done on a 5V, 50W converter using MOSFET to validate the performance of the converter. The converter has illustrated l...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Power Electronics
سال: 1991
ISSN: 0885-8993,1941-0107
DOI: 10.1109/63.65012