Consolidation of Fe-Based Metallic Glass Powders by Hot Pressing
نویسندگان
چکیده
منابع مشابه
Rapid consolidation of powdered materials by induction hot pressing.
A rapid hot press system in which the heat is supplied by RF induction to rapidly consolidate thermoelectric materials is described. Use of RF induction heating enables rapid heating and consolidation of powdered materials over a wide temperature range. Such rapid consolidation in nanomaterials is typically performed by spark plasma sintering (SPS) which can be much more expensive. Details of t...
متن کاملMg–Y–Cu bulk metallic glass prepared by mechanical alloying and vacuum hot-pressing
We have studied the amorphization behavior of Mg85KxY15Cux (xZ20–40) alloy powders synthesized by mechanical alloying technique. The as-milled powders were mainly amorphous after 10 h of milling. The thermal stability of these Mg85KxY15Cux glassy powders was investigated by differential scanning calorimeter (DSC). The ranges of Tg, Tx and DTx are around 430–459, 467–497, and 30–46 K, respective...
متن کاملA highly efficient degradation mechanism of methyl orange using Fe-based metallic glass powders
A new Fe-based metallic glass with composition Fe76B12Si9Y3 (at. %) is found to have extraordinary degradation efficiency towards methyl orange (MO, C14H14N3SO3) in strong acidic and near neutral environments compared to crystalline zero-valent iron (ZVI) powders and other Fe-based metallic glasses. The influence of temperature (294-328 K) on the degradation reaction rate was measured using bal...
متن کاملArgon-shielded hot pressing of titanium alloy (Ti6Al4V) powders.
The paper presents the method of the argon - shielded hot pressing of titanium alloy (Ti6A14V) powder (used in medical industry). The powders produced in the GA (gas atomization) process and in the HDH (hydride - dehydride) process were used in the experiments. A pressing process was conducted at a temperature of 800-850 degrees C for different lengths of time. An unoxidized sintered material, ...
متن کاملHigh pressure die casting of Fe-based metallic glass
Soft ferromagnetic Fe-based bulk metallic glass key-shaped specimens with a maximum and minimum width of 25.4 and 5 mm, respectively, were successfully produced using a high pressure die casting (HPDC) method, The influence of die material, alloy temperature and flow rate on the microstructure, thermal stability and soft ferromagnetic properties has been studied. The results suggest that a stee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research
سال: 2019
ISSN: 1980-5373,1516-1439
DOI: 10.1590/1980-5373-mr-2018-0581